|
CD54AC283 Datasheet, PDF (1/1 Pages) Intersil Corporation – 4-Bit Binary Full Adder with Fast Carry | |||
|
CD54AC283/3A
SEMICONDUCTOR
CD54ACT283/3A
COMPLETE DATA SHEET
June 1997
COMING SOON!
4-Bit Binary Full Adder with Fast Carry
Description
Functional Diagram
The CD54AC283/3A and CD54ACT283/3A are 4-bit binary
adders with fast carry that utilize the Harris Advanced CMOS
Logic technology. These devices add two 4-bit binary num-
bers and generate a carry-out bit if the sum exceeds 15.
Because of the symmetry of the add function, this device
can be used with either all active-HIGH operands (positive
logic) or with all active-LOW operands (negative logic).
When using positive logic, the carry-in input must be tied
LOW if there is no carry-in.
The CD54AC283/3A and CD54ACT283/3A are supplied in
16 lead dual-in-line ceramic packages (F sufï¬x).
ACT INPUT LOAD TABLE
INPUT
UNIT LOAD (NOTE 1)
5
A0
6
B0
3
A1
2
B1
14
A2
B2 15
A3 12
B3 11
7
CIN
A1, B1, A3, B3
1.33
A2, B2
1.5
A4, B4
1
CIN
0.83
NOTE:
1. Unit load is âICC limit speciï¬ed in DC Electrical Speciï¬cations
Table, e.g., 2.4mA Max at +25oC.
4
S0
1
S1
13
S2
10
S3
9
COUT
GND = 8
VCC = 16
Absolute Maximum Ratings
DC Supply Voltage, VCC . . . . . . . . . . . . . . . . . . . . . . . . -0.5V to +6V
DC Input Diode Current, IIK
For VI < -0.5V or VI > VCC + 0.5V . . . . . . . . . . . . . . . . . . . . . .±20mA
DC Output Diode Current, IOK
For VO < -0.5V or VO > VCC + 0.5V . . . . . . . . . . . . . . . . . . . . .±50mA
DC Output Source or Sink Current, Per Output Pin, IO
For VO > -0.5V or VO < VCC + 0.5V . . . . . . . . . . . . . . . . . . . . .±50mA
DC VCC or GND Current, ICC or IGND
For Up to 4 Outputs Per Device, Add ±25mA For Each
Additional Output . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .±100mA
Power Dissipation Per Package, PD
TA = -55oC to +100oC (Package F) . . . . . . . . . . . . . . . . . . 500mW
TA = +100oC to +125oC (Package F) . . . . . . . . Derate Linearly at
8mW/oC to 300mW
Operating Temperature Range, TA
Package Type F . . . . . . . . . . . . . . . . . . . . . . . . . . -55oC to +125oC
Storage Temperature, TSTG . . . . . . . . . . . . . . . . . . -65oC to +150oC
Lead Temperature (During Soldering)
At Distance 1/16in. ± 1/32in. (1.59mm ± 0.79mm)
From Case For 10s Max . . . . . . . . . . . . . . . . . . . . . . . . . . +265oC
Unit Inserted Into a PC Board (Min Thickness 1/16in., 1.59mm)
With Solder Contacting Lead Tips Only. . . . . . . . . . . . . . . +300oC
CAUTION: Stresses above those listed in âAbsolute Maximum Ratingsâ may cause permanent damage to the device. This is a stress only rating and operation
of the device at these or any other conditions above those indicated in the operational sections of this speciï¬cation is not implied.
Recommended Operating Conditions
Supply Voltage Range, VCC
Unless Otherwise Speciï¬ed, All Voltages Referenced to GND
TA = Full Package Temperature Range
CD54AC Types . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.5V to 5.5V
CD54ACT Types . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4.5V to 5.5V
DC Input or Output Voltage, VI, VO. . . . . . . . . . . . . . . . . . 0V to VCC
Operating Temperature, TA . . . . . . . . . . . . . . . . . . . -55oC to +125oC
Input Rise and Fall Slew Rate, dt/dv
at 1.5V to 3V (AC Types) . . . . . . . . . . . . . . . . . . . 0ns/V to 50ns/V
at 3.6V to 5.5V (AC Types) . . . . . . . . . . . . . . . . . 0ns/V to 20ns/V
at 4.5V to 5.5V (AC Types) . . . . . . . . . . . . . . . . . 0ns/V to 10ns/V
CAUTION: These devices are sensitive to electrostatic discharge. Users should follow proper I.C. Handling Procedures.
Copyright © Harris Corporation 1994
1
File Number 3906
|