|
CD54AC109 Datasheet, PDF (1/1 Pages) Intersil Corporation – Dual J-K Flip-Flop with Set and Reset | |||
|
SEMICONDUCTOR
June 1997
COMPLETE DATA SHEET
COMING SOON!
CD54AC109/3A
CD54ACT109/3A
Dual âJ-Kâ Flip-Flop with Set and Reset
Description
The CD54AC109/3A and CD54ACT109/3A are dual âJ-Kâ
ï¬ip-ï¬ops with set and reset that utilize the Harris Advanced
CMOS Logic technology. These ï¬ip-ï¬ops have independent
J, K, Set, Reset and Clock inputs and Q and Q outputs. The
CD54AC109/3A and CD54ACT109/3A changes state on the
positive-going transition of the clock. Set and Reset are
accomplished asynchronously by low-level inputs.
The CD54AC109/3A and CD54ACT109/3A are supplied in
16 lead dual-in-line ceramic packages (F sufï¬x).
Functional Diagram
5
1S
2
1J
3
1K
4
1CP
1
1R
2S 11
FF 1
ACT INPUT LOAD TABLE
INPUT
UNIT LOAD (NOTE 1)
J, CP, CP
1
K
0.53
S, R
0.58
NOTE:
1. Unit load is âICC limit speciï¬ed in DC Electrical Speciï¬cations
Table, e.g., 2.4mA Max at +25oC.
14
2J
13
2K
12
2CP
2R 15
FF 2
6
1Q
7
1Q
10
2Q
9
2Q
GND = 8
VCC = 16
Absolute Maximum Ratings
DC Supply Voltage, VCC . . . . . . . . . . . . . . . . . . . . . . . . -0.5V to +6V
DC Input Diode Current, IIK
For VI < -0.5V or VI > VCC + 0.5V . . . . . . . . . . . . . . . . . . . . . .±20mA
DC Output Diode Current, IOK
For VO < -0.5V or VO > VCC + 0.5V . . . . . . . . . . . . . . . . . . . . .±50mA
DC Output Source or Sink Current, Per Output Pin, IO
For VO > -0.5V or VO < VCC + 0.5V . . . . . . . . . . . . . . . . . . . . .±50mA
DC VCC or GND Current, ICC or IGND
For Up to 4 Outputs Per Device, Add ±25mA For Each
Additional Output . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .±100mA
Power Dissipation Per Package, PD
TA = -55oC to +100oC (Package F) . . . . . . . . . . . . . . . . . . 500mW
TA = +100oC to +125oC (Package F) . . . . . . . . Derate Linearly at
8mW/oC to 300mW
Operating Temperature Range, TA
Package Type F . . . . . . . . . . . . . . . . . . . . . . . . . . -55oC to +125oC
Storage Temperature, TSTG . . . . . . . . . . . . . . . . . . -65oC to +150oC
Lead Temperature (During Soldering)
At Distance 1/16in. ± 1/32in. (1.59mm ± 0.79mm)
From Case For 10s Max . . . . . . . . . . . . . . . . . . . . . . . . . . +265oC
Unit Inserted Into a PC Board (Min Thickness 1/16in., 1.59mm)
With Solder Contacting Lead Tips Only. . . . . . . . . . . . . . . +300oC
CAUTION: Stresses above those listed in âAbsolute Maximum Ratingsâ may cause permanent damage to the device. This is a stress only rating and operation
of the device at these or any other conditions above those indicated in the operational sections of this speciï¬cation is not implied.
Recommended Operating Conditions
Supply Voltage Range, VCC
Unless Otherwise Speciï¬ed, All Voltages Referenced to GND
TA = Full Package Temperature Range
CD54AC Types . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.5V to 5.5V
CD54ACT Types . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4.5V to 5.5V
DC Input or Output Voltage, VI, VO. . . . . . . . . . . . . . . . . . 0V to VCC
Operating Temperature, TA . . . . . . . . . . . . . . . . . . . -55oC to +125oC
Input Rise and Fall Slew Rate, dt/dv
at 1.5V to 3V (AC Types) . . . . . . . . . . . . . . . . . . . 0ns/V to 50ns/V
at 3.6V to 5.5V (AC Types) . . . . . . . . . . . . . . . . . 0ns/V to 20ns/V
at 4.5V to 5.5V (AC Types) . . . . . . . . . . . . . . . . . 0ns/V to 10ns/V
CAUTION: These devices are sensitive to electrostatic discharge. Users should follow proper I.C. Handling Procedures.
Copyright © Harris Corporation 1994
1
File Number 3885
|