|
CA3275 Datasheet, PDF (1/5 Pages) Intersil Corporation – Dual Full Bridge Driver | |||
|
CA3275
April 1994
Dual Full Bridge Driver
Features
Description
⢠Two Full Bridge Drivers
⢠± 150mA Maximum Current
⢠Logic Controlled Switching
⢠Direction Control
⢠PWM IOUT Control
⢠18V Over-Voltage Protection
⢠300mA Short-Circuit Protection
⢠Nominal 8V to 16V Operation
⢠Internal Voltage Regulation With Bandgap Reference
Applications
⢠Dual Full Bridge Driver For Air Core Gauge Instrumen-
tation
⢠µP Controlled Sensor Data Displays
⢠Speedometer Displays
The CA3275 Dual Full Bridge Driver is intended for general-
purpose applications requiring Dual Full Bridge drive or
switching, including direction and pulse-width modulation for
position control. While all features of the IC may not be uti-
lized or required, they would normally be used in instrumen-
tation systems with quadrature coils, such as air-core
gauges, where the coils would be driven at frequencies rang-
ing from 200Hz to 400Hz. The coils are wrapped at 90o
angles for independent direction control. Coils wound in this
physical conï¬guration are controlled by pulse width modula-
tion, where each coil drive is a function of the sine or cosine
versus degrees of movement. The direction control is used
to change the direction of the current in the H-Driver coil.
The switch rate capability of the IC is typically 30kHz regard-
less of the inductive load. Over-current limiting is used to
limit short circuit current. Over-voltage protection (in the
range of 18V to 24V) causes the device to shut down the
output current drive. Thermal shutdown limits power dissipa-
tion on the chip. The CA3275 is supplied in a 14 lead dual-in-
line plastic package.
⢠Tachometer Displays
⢠Stepper Motors
Ordering Information
⢠Slave Position Indicators
PART NO.
CA3275E
TEMPERATURE
-40oC to +85oC
PACKAGE
14 Lead Plastic DIP
Pinout
CA3275 (PDIP)
TOP VIEW
Block Diagram
COIL A- 1
VCC 2
VCC 3
PWMB 4
DIR B 5
VCC 6
COIL B- 7
14 COIL A+
13 GND
12 PWMA
11 DIR A
10 GND
9 GND
8 COIL B+
SENSOR &
CONVERTER
A/D, V/F, ETC
MICROPROCESSOR
PHASE, DIRECTION
& PWM CONTROL
CA3275
DUAL-H
DRIVER
LA SIN
ROTOR
LB COS
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Copyright © Intersil Corporation 1999
6-3
File Number 2159.3
|
▷ |