5962-0620705Q3A Datasheet, PDF (1/9 Pages) Intersil Corporation – ±15kV ESD Protected, +5.0V 1Microamp, 250kbps, RS-232 Transmitters/Receivers

5962-0620705Q3A, 5962-0620706Q3A,
®
5962-0620707Q2A, 5962-0620708Q2A
Data Sheet
May 31, 2006
FN6298.0
±15kV ESD Protected, +5.0V 1Microamp,
250kbps, RS-232 Transmitters/Receivers
The Intersil 5962-062070xQxA devices are 5.0V powered
RS-232 transmitters/receivers which meet ElA/TIA-232 and
V.28/V.24 specifications. Additionally, they provide ±15kV
ESD protection (IEC61000-4-2 Air Gap and MIL-STD 883
Human Body Model) on transmitter outputs and receiver
inputs (RS-232 pins). Targeted applications include
ruggedized portable products and remotely deployed
devices exposed to extreme temperature and humidity
where the low operational and even lower standby, power
consumption is critical. Efficient on-chip charge pumps,
coupled with manual and automatic power-down functions
(except for the 5962-0620707Q2A), reduce the standby
supply current to a 1µA trickle. Small footprint packaging and
the use of small, low value capacitors ensure board space
savings as well. Data rates greater than 250kbps are
guaranteed at worst case load conditions. This family is fully
compatible with 5.0V-only systems.
Specifications for QML devices are controlled by the
Defense Supply Center in Columbus (DSCC). The SMD
numbers listed here must be used when ordering.
Detailed Electrical Specifications for these devices are
contained in SMD 5962-06207. A “hot-link” is provided
on our website for downloading.
Ordering Information
DESC P/N
CONFIGURATION TEMP (°C) PACKAGE
5962-0620705Q3A ICL3243E 3D/5R -55 to +125 28 Ld CLCC
5962-0620706Q3A ICL3238E 5D/3R -55 to +125 28 Ld CLCC
5962-0620707Q2A ICL3232E 2D/2R -55 to +125 20 Ld CLCC
5962-0620708Q2A ICL3221E 1D/1R -55 to +125 20 Ld CLCC
Features
• Meets EIA/TIA-232 and V.28/V.24 Specifications at 5V
• Electrically Screened to DSCC SMD#5962-06207
• QML Qualified per MIL-PRF-38535 Requirements
• SMD Compliance
• Military Temperature Range
• Latch-up Free
• Hermetic Package
• ESD Protection for RS-232 I/O Pins to ±15kV (IEC61000)
• Guaranteed Mouse Driveability (ICL3243E)
• Requires Single +5.0V ±10% Power Supply
• Receiver Hysteresis for Improved Noise Immunity
• Low Power Automatic Power-down Modes
(Except for ICL3232E) . . . . . . . . . . . . . . . . . . . . . . . . .1µA
• Guaranteed Minimum 250kbps Data Rate
• Manual and Automatic Power-down Features
• Multiple Drivers/Receivers
• On-Chip Voltage Converters Require Only Four External
Capacitors
• Regulated Dual Charge Pumps
Applications
• Any Military or High-Rel System Requiring RS-232
Communication Ports
- Battery Powered, Hand-Held, and Portable Equipment
- Ruggedized Handheld GPS, Laptop Computers,
Notebooks, Palmtops
- Industrial Control/Shop Floor Communications
- Field Deployed Sensors/Devices Exposed to Extreme
Temperature/Humidity
- Ruggedized Cellular/Mobile Phones
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2006. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.