MS7212_08 Datasheet, PDF (4/4 Pages) Intersema Sensoric SA – PRESSURE SENSOR DIE (0-12 BAR) FOR HARSH ENVIRONMENT

PICKING TOOLS
The MS7212 sensors have a topside Pyrex™ cap (1.23 x 1.02 mm²) and a backside Pyrex™ (1.95 x 1.63 mm²).
The pick and place tool has to be of a soft material as rubber (Hardness 78-97 Shore A). Its external size must
fit the Pyrex™ cap. Successful tests were done with some tools of SPT (see SPT drawing and references
bellow).
SPT references
External dimension
Internal dimensions
RTR-A1-060x060
TL & TW: 0.06 inch /1.52 mm
∅H: 0.035 inch / 0.89 mm
WIRE BONDING
The bondable area is 100 x 100 µm². The location of the bonding pads is close to the top Pyrex glass edge
reducing the possible size and angle of the bonding capillary. Refer to the detail view D on the layout for more
precision.
ORDERING INFORMATION
Product Code
type
MS7212-A
Absolute
Product
12 bar Pressure Sensors sawn on b/f
The MS7212 dice are supplied sawn on blue foil, mounted on plastic rings
FACTORY CONTACTS
Art.-Nr.
721225021
Intersema Sensoric SA
Ch. Chapons-des-Prés 11
CH-2022 BEVAIX
SWITZERLAND
Tel. [phone]
Tel. Int. [phone]
Telefax [phone]
e-mail:
http://www.intersema.ch
NOTICE
Intersema reserves the right to make changes to the products contained in this data sheet in order to improve the design or performance
and to supply the best possible products. Intersema assumes no responsibility for the use of any circuits shown in this data sheet, conveys
no license under any patent or other rights unless otherwise specified in this data sheet, and makes no claim that the circuits are free from
patent infringement. Applications for any devices shown in this data sheet are for illustration only and Intersema makes no claim or
warranty that such applications will be suitable for the use specified without further testing or modification.
DA7212_004.doc
October 6, 2008
4/4
00007212583
ECN 1145