SMRT283R3S_16 Datasheet, PDF (1/44 Pages) Interpoint Corporation Company – SMRT Single, Dual and Triple Space DC-DC Converters

Crane Aerospace & Electronics Power Solutions
SMRT Single, Dual and Triple Space DC-DC Converters
19-56 Volt input – 35 Watt – Space qualified
Features
• Radiation tolerant space dc-dc converter
-- Single event effects (SEE) LET performance to
86 MeV cm²/mg
-- Total ionizing dose (TID) guaranteed per MIL-STD-883
method 1019, radiation hardness assurance (RHA)
P = 30 krad(Si), L = 50 krad(Si), R = 100 krad(Si)
-- 50 - 300 rad(Si)/sec dose rate (Condition A)
-- 10 mrad(Si)/sec dose rate (Condition D)
• Built in MIL-STD-461 EMI filter
• Output trim from 51% to 124% of nominal
• Operating temperature -55° to +125°C
• Qualified to MIL-PRF-38534 Class H and K
• Input voltage range 19 to 56 volts
• Transient protection 80 volts for 120 ms
• Fully isolated, 5 port isolation
• Dual magnetic feedback
• Fixed high frequency switching
• Remote sense
• Inhibit function
• Synchronization input
• Indefinite short circuit protection
• Meets MIL-STD-704A transient standards
SINGLE
3.3
5
8.7
12
15
models
Output Voltage (V)
DUAL
Vout A 5 V, Vout B 5 V
Vout A 12 V, Vout B 12 V
Vout A 15 V, Vout B 15 V
TRIPLE
+3.3 & ±12
+3.3 & ±15
+5 & ±7
+5 & ±12
+5 & ±15
description
The Interpoint^® SMRT Series™ of dc-dc converters offers up
to 35 watts of power in a radiation tolerant design. The low
profile SMRT converters are manufactured in our fully certified
and qualified MIL-PRF-38534 production facility and packaged
in hermetically sealed steel cases. They are ideal for use in
programs requiring high reliability, small size, and high levels of
radiation hardness assurance.
The SMRT converters are switching regulators which use a
two-phase, phase shifted flyback design with a nominal switching
frequency of 300 kHz. Close regulation is maintained with
advanced constant frequency pulse width modulation design
techniques. The SMRT’s feed-forward compensation and
discontinuous topologies provide high levels of input-to-output
ripple rejection. See Figure 10 on page 29, Figure 29 and
Figure 30 on page 33 and Figure 45 and Figure 46 on page
36.
Two independent feedback loops are used to regulate the dual
and triple outputs, one feedback loop regulates the two-phased
single output. Each set of outputs is electrically isolated from the
other and from the input. This product configuration eliminates
cross regulation effects between output sets.
Configurations:
• Single Output: One dual-phase output
• Dual Output: Two isolated single-phase outputs
• Triple Output: One single-phased output (Main) isolated
from one single-phase dual output (± Auxiliary)
Crane Aerospace & Electronics
Power Solutions – Interpoint Products
10301 Willows Rd. NE, Redmond, WA 98052
[phone] • [e-mail]
www.craneae.com/interpoint
Page 1 of 44
SMRT28 Rev AJ - 2016.05.03