MQO28512Q Datasheet, PDF (1/7 Pages) Interpoint Corporation Company – DC/DC CONVERTERS 28 VOLT INPUT

FEATURES
• –55°C to +125° C operation
• 16 TO 40 VDC input
• Four fully regulated outputs
• Internal EMI filter meets
MIL-STD-461C CE03
• Active transient suppressor
• Built in hold-up function with flag
• Fully isolated
• Magnetic feedback
• Fixed frequency, 550 kHz typical
• Topology – Single Ended Forward
• Inhibit function
• Indefinite short circuit protection
• Undervoltage lockout
DC/DC CONVERTERS
28 VOLT INPUT
MQO SERIES
16 WATT
MODELS
VDC OUTPUT
QUAD
±5 and ±12
±5 and ±15
Size (max.): 3.200 x 2.600 x 0.460 inches (81.28 x 66.04 x 11.68 mm)
See Section B8, case N, for dimensions.
Weight: 120 grams typical
Screening: Standard or ES. See Section C2 for screening options,
see Section A5 for ordering information.
DESCRIPTION
The MQO Series™ of DC/DC converters supply up to 16.5 watts in
a four output configuration of ±5 and ±12 or ±5 and ±15 VDC. An
integral EMI filter and transient suppressor allow the converters to
meet MIL-STD-461C standards without external components. An
output hold-up feature provides a low power flag and full output
power hold-up through transient dropout conditions.
The MQO Series converters are packaged in hermetically sealed
cases and are rated for full power operation from –55° to +125° C
case temperature. This makes these units ideal for military, aero-
space, and hi-rel industrial applications.
A high gain bandwidth magnetically isolated control loop is used to
precisely regulate the +5 VDC output. Constant frequency pulse
width with a single ended forward topology is used. The –5 VDC
output and the auxiliary outputs are independently controlled with
low headroom regulators, eliminating cross regulation errors. The
use of feedforward, compensation, and a high gain bandwidth
control loop provides excellent rejection to the conducted audio
spectrum of MIL-STD-704A-D and MIL-STD-461C.
INTEGRAL EMI FILTER
The MQO Series includes a a built-in EMI filter and transient
suppressor which allow the units to meet the most common military
standards without any external components. The internal EMI filter
provides both differential and common mode attenuation on the
input power lines to allow meeting the CE03 interference and CS02
susceptibility requirements. The active internal transient suppressor
provides protection against MIL-STD-704A, 1275, and 461C line
transients. Protection is provided for transients up to 400 V from a
0.5 ohm source and 600 V from a 50 ohm source.
BUILT-IN HOLD-UP FUNCTION WITH FLAG
An output hold-up feature provides a low power flag and full output
power hold-up through transient drop out conditions. At full load for
a Vin step from 28 to 0 volts, the minimum hold-up time will be 50
µs. The low power flag (TTL high) is asserted 10 µs before the end
of the hold-up time. External capacitance can be added to extend
hold-up time.
SHORT CIRCUIT PROTECTION
MQO Series converters provide predictable current limiters which
directly sense output load current in the converter’s secondary.
During short circuit or overload conditions, the current limiters
provide constant output current and an input power fold-back.
UNDERVOLTAGE LOCKOUT
Undervoltage lockout prevents the converters from operating below
approximately 12 VDC input voltage which helps keep system
current levels smooth, especially during initialization or re-start oper-
ations.
B2-53