D53427RKE Datasheet, PDF (69/82 Pages) Intel Corporation – This product specification applies to only the standard Intel® NUC Board with BIOS identifier RKPPT10H.86A.

4 Error Messages and Blink Codes
4.1 Front-panel Power LED Blink Codes
Whenever a recoverable error occurs during POST, the BIOS causes the board’s front
panel power LED to blink an error message describing the problem (see Table 26).
Table 26. Front-panel Power LED Blink Codes
Type
Pattern
BIOS update in progress
Video error ^(Note)
Off when the update begins, then on for
0.5 seconds, then off for 0.5 seconds. The
pattern repeats until the BIOS update is
complete.
On-off (1.0 second each) two times, then
2.5-second pause (off), entire pattern repeats
(blink and pause) until the system is powered
off.
Memory error
On-off (1.0 second each) three times, then
2.5-second pause (off), entire pattern repeats
(blinks and pause) until the system is powered
off.
Thermal trip warning
Each beep will be accompanied by the following
blink pattern: .25 seconds on, .25 seconds off,
.25 seconds on, .25 seconds off. This will result
in a total of 16 blinks.
Note: Disabled per default BIOS setup option.
Note
When no VGA option ROM is
found.
4.2 BIOS Error Messages
Table 27 lists the error messages and provides a brief description of each.
Table 27. BIOS Error Messages
Error Message
Explanation
CMOS Battery Low
CMOS Checksum Bad
The battery may be losing power. Replace the battery soon.
The CMOS checksum is incorrect. CMOS memory may have
been corrupted. Run Setup to reset values.
Memory Size Decreased
Memory size has decreased since the last boot. If no memory
was removed, then memory may be bad.
No Boot Device Available
System did not find a device to boot.
69