FW82801BASL5PN Datasheet, PDF (352/671 Pages) Intel Corporation – Intel® 82801EB I/O Controller Hub 5 (ICH5) / Intel® 82801ER I/O Controller Hub 5 R (ICH5R)

LPC Interface Bridge Registers (D31:F0)
9.3.1
TCW—Timer Control Word Register
(LPC I/F—D31:F0)
I/O Address:
Default Value:
43h
All bits undefined
Attribute:
Size:
WO
8 bits
This register is programmed prior to any counter being accessed to specify counter modes.
Following part reset, the control words for each register are undefined and each counter output is 0.
Each timer must be programmed to bring it into a known state.
Bit
Description
Counter Select — WO. The Counter Selection bits select the counter the control word acts upon as
shown below. The Read Back Command is selected when bits[7:6] are both 1.
00 = Counter 0 select
7:6 _{01 = Counter 1 select}
10 = Counter 2 select
11 = Read Back Command
Read/Write Select — WO. These bits are the read/write control bits. The actual counter
programming is done through the counter port (40h for counter 0, 41h for counter 1, and 42h for
counter 2).
5:4 ^{00 = Counter Latch Command}
01 = Read/Write Least Significant Byte (LSB)
10 = Read/Write Most Significant Byte (MSB)
11 = Read/Write LSB then MSB
Counter Mode Selection — WO. These bits select one of six possible modes of operation for the
selected counter.
000 = Mode 0 Out signal on end of count (=0)
001 = Mode 1 Hardware retriggerable one-shot
3:1 _{x10 = Mode 2 Rate generator (divide by n counter)}
x11 = Mode 3 Square wave output
100 = Mode 4 Software triggered strobe
101 = Mode 5 Hardware triggered strobe
Binary/BCD Countdown Select — WO.
0
0 = Binary countdown is used. The largest possible binary count is 216
1 = Binary coded decimal (BCD) count is used. The largest possible BCD count is 104
There are two special commands that can be issued to the counters through this register, the Read
Back Command and the Counter Latch Command. When these commands are chosen, several bits
within this register are redefined. These register formats are described below.
352
Intel^® 82801EB ICH5 / 82801ER ICH5R Datasheet