D201GLY Datasheet, PDF (24/76 Pages) Intel Corporation – Technical Product Specification

Intel Desktop Board D201GLY Technical Product Specification
1.7.2 Parallel Port
The 25-pin D-Sub parallel port connector is located on the back panel. Use the BIOS
Setup program to set the parallel port mode.
For information about
The location of the parallel port connector
Refer to
Figure 6, page 37
1.7.3 Keyboard and Mouse Interface
PS/2 keyboard and mouse connectors are located on the back panel.
NOTE
The keyboard is supported in the bottom PS/2 connector and the mouse is supported
in the top PS/2 connector. Power to the computer should be turned off before a
keyboard or mouse is connected or disconnected.
For information about
The location of the keyboard and mouse connectors
Refer to
Figure 6, page 37
1.8 Audio Subsystem
The audio subsystem consists of the following devices:
• SiS964L Southbridge
• ADI AD1888 audio codec
The audio subsystem includes these features:
• Signal-to-noise ratio ≥ 90 dB
• Supports wake events (driver dependent)
• Mic in pre-amp that supports dynamic, condenser, and electret microphones
The audio subsystem supports the following audio interfaces:
• Front panel audio header, including pins for:
⎯ Line out
⎯ Mic in
• Back panel audio connectors:
⎯ Line in
⎯ Line out
⎯ Mic in
1.8.1 Audio Subsystem Software
Audio software and drivers are available from Intel’s World Wide Web site.
For information about
Obtaining audio software and drivers
Refer to
Section 1.1.4, page 14
24