DG43NB Datasheet, PDF (15/88 Pages) Intel Corporation – Technical Product Specification

Product Description
# ^{INTEGRATOR’S NOTE}
Use only ATX12V-compliant power supplies.
For information about
Power supply connectors
Refer to
Section 2.2.2.4, page 49
1.5 System Memory
The board has two DIMM sockets and supports the following memory features:
• 1.8 V DDR2 SDRAM DIMMs with gold plated contacts, with the option to raise the
voltage to support higher performance DDR2 SDRAM DIMMs
• Dual channel interleaved mode support
• Unbuffered, single-sided or double-sided DIMMs with the following restriction:
Double-sided DIMMs with x16 organization are not supported.
• 4 GB maximum total system memory. Refer to Section 2.1.1 on page 39 for
information on the total amount of addressable memory.
• Minimum total system memory: 512 MB
• Non-ECC DIMMs
• Serial Presence Detect
• DDR2 667 MHz or DDR2 800 MHz SDRAM DIMMs
• DDR2 667 MHz DIMMs with SPD timings of only 5-5-5 (tCL-tRCD-tRP)
• DDR2 800 MHz DIMMs with SPD timings of only 5-5-5 or 6-6-6 (tCL-tRCD-tRP)
NOTE
To be fully compliant with all applicable DDR SDRAM memory specifications, the board
should be populated with DIMMs that support the Serial Presence Detect (SPD) data
structure. This enables the BIOS to read the SPD data and program the chipset to
accurately configure memory settings for optimum performance. If non-SPD memory
is installed, the BIOS will attempt to correctly configure the memory settings, but
performance and reliability may be impacted or the DIMMs may not function under the
determined frequency.
Table 3 lists the supported DIMM configurations.
Table 3. Supported Memory Configurations
DIMM
Type
SDRAM
Technology
Smallest usable
DIMM (one x16
Single-sided
DIMM)
Largest usable
DIMM (one x8
Double-sided
DIMM)
DDR2 667 512 Mbit
256 MB
1 GB
DDR2 800 512 Mbit
256 MB
1 GB
Maximum capacity
with four identical
x8 Double-sided
DIMMs
4 GB
4 GB
For information about…
Tested Memory
Refer to:
http://support.intel.com/support/motherboards/desktop/sb/
CS-025414.htm
15