|
83C196LC Datasheet, PDF (12/22 Pages) Intel Corporation – CHMOS 16-BIT MICROCONTROLLER | |||
|
◁ |
83C196LC, 83C196LD â AUTOMOTIVE
5.1 DC Characteristics
Symbol
Table 6. DC Characteristics at VCC = 4.5V â 5.5V
Parameter
Min Typical Max Units
Test Conditions
ICC
VCC supply current
(â40° C to +125° C
ambient)
ICC1
Active mode supply cur-
rent (typical)
FXTAL1 = 20 MHZ,
88
mA VCC = VPP = 5.5V
(While device is in reset)
55
mA
IIDLE
Idle mode current
IPD
Powerdown mode
current
20
40
mA FXTAL1 = 20 MHz,
VCC = VPP = 5.5V
50
TBD
µA
VCC = VPP = 5.5V
(Note 6)
VIL
Input low voltage
(all pins)
â0.5V
0.3 VCC
V
VIH
Input high voltage (all
0.7 VCC
pins)
VCC + 0.5 V
VOL
Output low voltage
(outputs configured as
complementary)
VOH
Output high voltage
VCC â 0.3
(outputs configured as VCC â 0.7
complementary)
VCC â 1.5
0.3
0.45
1.5
V IOL = 200 µA (Notes 3, 5)
V IOL = 3.2 mA
V IOL = 7.0 mA
V IOH = â200 µA (Notes 3, 5)
V IOH = â3.2 mA
V IOH = â7.0 mA
ILI
Input leakage current
(standard inputs, ports
3 & 4)
± 10
µA VSS ⤠VIN ⤠VCC (Note 2)
ILI1
Input leakage current
(port 0)
± 2.0
µA VSS ⤠VIN ⤠VREF
IIH
Input high current (NMI
pin)
+175
µA VSS ⤠VIN ⤠VCC
VOH2
Output high voltage in
reset
VCC â 1V
V IOH = â15 µA (Note 1)
IOH2
Output high current in
â25
reset
â45
â50
â120
â240
â280
µA VOH2 = VCC â 1.0V
µA VOH2 = VCC â 2.5V
µA VOH2 = VCC â 4.0V
RRST
Reset pullup resistor
6K
65K
â¦
NOTES:
1. All bidirectional pins except CLKOUT. CLKOUT is not pulled weakly high in reset. Bidirectional pins
include ports 1â6.
2. Standard input pins include XTAL1, EA#, RESET#, P0.7:2, and ports 1â6 when configured as inputs.
3. All bidirectional pins when configured as complementary outputs.
4. Device is static and should operate below 1 Hz, but is only tested down to 4 MHz.
5. Maximum IOLor IOH currents per pin will be characterized and published at a later date. Target values
are ± 10 mA.
6. Typicals are based on a limited number of samples and are not guaranteed. The values listed are at
room temperature and VCC = 5.0V.
12
ADVANCE INFORMATION
|
▷ |