|
INF8582E Datasheet, PDF (1/8 Pages) Integral Corp. – 256 Х 8 BIT STATIC CMOS EEPROM WITH I2С-BUS. ( ANALOG - MICROCIRCUIT PCF8582Е, F.PHILIPS). | |||
|
INF8582E
256 Х 8 BIT STATIC CMOS EEPROM WITH I2С-BUS.
( ANALOG - MICROCIRCUIT PCF8582Ð, F.PHILIPS).
INF8582E - 2Ðbit (256Ñ
8 bit) electronically erasable programmable ROM with
âfloatingâ gate. Internal reduntant code correcting errors as single bit errors is used to
enhance the reliability. Microcircuit operates in systems with serial I2C-bus consisting of
two lines: for data signals (SDA) (bidirectional) and for clock signals (SCL). Up to 8 mi-
crocircuits may be connected to I2C-bus. Stacker programming is done by tunneling
electrons. Programming voltage is generated by voltage multiplier built-in chip. The im-
plementation of CMOS technology in full provides low power consumption.
These products are purposed for implementation in portable consumer applica-
tions, in autoelectronics, in peripheric computer devices. Thea are used in TV chan-
nel selectors, for storage of frequency, volume and image data, in tuning control blocks
in radioset,
, in measuring devices for standard curves storage, calibration data,
minimum and maximum values, in , seat position adgusting systems, side glass, in
speedometers.
Characteristic properties:
- without decay storage 2 Ðbit 10 years;
- single-error correction circuit;
- one power supply (UÑÑ=4,5V - 5,5V);
- built-in voltage multiplier in chip;
- input/output consecutive bus ;
- automatic increment of word address;
- internal timer for recording;
- 100 000 cycles erasure/recording on byte with low failure rate;
- unlimited number of reading cycles;
- low power consumption;
- temperature range -40 - +85 ÐС.
The basing circuit diagram and Pins purpose table are given below in fig.1, main
electrical characteristics are indicated in Table 1.
Microcircuit basing diagram
Pins purpose table
Ð
Ð
12 87
Ð
36
Uss
45
Ucc
TEST
SCL
SDA
Package: 2101.8-A
РиÑ.1
Pin â
1
2
3
4
5
6
7
8
Sym-
bol
A0
A1
A2
Uss
SDA
SCL
ТÐSТ
Ucc
Purpose
address input
address input
address input
"ground"
data line, input/output
clock signal line (input)
synchronizing signal of programming
power supply
1
|
▷ |