English
Language : 

IA64F3048SEC Datasheet, PDF (1/2 Pages) InnovASIC, Inc – SECURITY-ENHANCED MICROCONTROLLER
IA64F3048SEC
Advance Information Sheet
SECURITY-ENHANCED MICROCONTROLLER
FEATURES
•
4 Kbytes SRAM
•
128 Kbytes EEPROM
•
Additional 32x32 multiply instruction
•
Hardware random number generator
•
30MHz Clock Rate
•
5V and 3.3V versions planned
•
Sixteen 16-bit general registers
•
Flexible instruction set built on 62 basic instruction types
•
8/16/32-bit data transfer, arithmetic, and logic instructions
•
Signed and unsigned multiply and divide instructions
•
Extensive bit manipulation instructions
•
Bus controller with 8-bit access
•
3-function refresh controller
•
DMA controller with short or full address mode
•
16-bit integrated timer unit (ITU) with 5 channels
•
Programmable timing pattern controller (TPC)
•
Watchdog timer
•
Serial communications interface (SCI) with built-in smart card interface
•
Eight 10-bit A/D converter channels
•
Two 8-bit D/A converter channels
•
Clock pulse generator
•
Interrupt controller with 37 sources
•
Seventy input/output pins and eight input-only pins
•
Available in 100 pin QFP package
The IA64F3048SEC is code compatible with the original Hitachi® H8/300H family of
microcontrollers, with additional security enhancements designed into the device. innovASIC
produces replacement ICs using its MILESTM, or Managed IC Lifetime Extension System, cloning
technology. This technology produces replacement ICs far more complex than "emulation" while
ensuring they are compatible with the original IC. MILESTM captures the design of a clone so it
can be produced even as silicon technology advances. MILESTM also verifies the clone against the
original IC so that even the "undocumented features" are duplicated.
This Advanced Information Sheet contains preliminary information for this the IA64F3048SEC.
The complete data sheet which documents all necessary engineering information about the
IA64F3048SEC including functional and I/O descriptions, electrical characteristics, and
applicable timing will be available when the device nears completion.
Copyright © 2001
innovASIC
The End of Obsolescence™
Page 1 of 2
www.innovasic.com
Customer Support:
1-888-824-4184