TLE4946-2L Datasheet, PDF (9/12 Pages) Infineon Technologies AG – High Precision Hall Effect Latch

TLE4946-2L
Specification
Attention: Stresses above the max. values listed here may cause permanent damage to the device.
Exposure to absolute maximum rating conditions for extended periods may affect device
reliability. Maximum ratings are absolute ratings; exceeding only one of these values may
cause irreversible damage to the integrated circuit.
3.3
Operating Range
The following operating conditions must not be exceeded in order to ensure correct operation of the TLE4946-2L.
All parameters specified in the following sections refer to these operating conditions unless otherwise mentioned.
Table 3 Operating Range
Parameter
Symbol
Supply voltage
V_S
Output voltage
V_Q
Junction temperature
T_j
Output current
I_Q
Min.
2.7
– 0.7
– 40
0
Values
Typ.
–
–
–
–
Max.
18
18
150
20
Unit Note/ Test Condition
V
V
°C
mA
3.4
Characteristics
Product characteristics involve the spread of values guaranteed within the specified voltage and ambient
temperature range. Typical characteristics are the median of the production (at V_s = 12V and T_A= 25°C).
Table 4 Electrical Characteristics
Parameter
Symbol
Values
Unit Note/ Test Condition
Min.
Typ.
Max.
Supply current
I_S
2
4
6
mA V_S = 2.7 V ... 18 V
Reverse current
I_SR
0
0.2
1
mA V_S = – 18 V
Output saturation voltage
V_QSAT
–
0.3
0.6
V
I_Q = 20 mA
Output leakage current
I_QLEAK
–
0.05
10
µA for V_Q = 18 V
Output fall time
Output rise time
t_f
–
0.02
1
µs
R_L = 1.2 kΩ;
t_r
–
0.4
1
µs
C_L = 50 pF
Chopper frequency
Switching frequency
Delay time ²⁾
Output jitter ³⁾
f_OSC
–
f_SW
0
t_d
–
t_QJ
–
320
–
kHz
–
15 ¹⁾
kHz
13
–
µs
1
–
µs_RMS Typ. value for square
wave signal 1 kHz
Power-on time ⁴⁾
t_PON
–
13
–
µs
V_S ≥ 2.7 V
Thermal resistance ⁵⁾
R_thJA
–
190
K/W PG-SSO-3-2
1) To operate the sensor at the max. switching frequency, the value of the magnetic signal amplitude must be 1.4 times higher
than for static fields.
This is due to the - 3 dB corner frequency of the low pass filter in the signal path.
2) Systematic delay between magnetic threshold reached and output switching
3) Jitter is the unpredictable deviation of the output switching delay
4) Time from applying V_S ≥ 2.7 V to the sensor until the output state is valid
5) Thermal resistance from junction to ambient
Datasheet
9
Rev 1.0, 2008-06