SAB82525N Datasheet, PDF (82/126 Pages) Infineon Technologies AG – Data Communications ICs

Interrupt Status Register (READ)
7
ISTA
RME RPF RSC XPR TIN
SAB 82525
SAB 82526
SAF 82525
SAF 82526
0
ICA EXA EXB
(20/60)
Value after RESET: 00_H
RME. . .Receive Message End
One message up to 32 bytes or the last part of a message greater then 32 bytes has
been received and is now available in the RFIFO. The message is complete!
The actual message length can be determined reading the RBCH, RBCL registers.
Additional information is available in the RSTA register.
RPF. . .Receive Pool Full
A block of 32 bytes of a message is stored in the RFIFO. The message is not yet
completed!
Note: This interrupt is only generated in Interrupt Mode!
RSC. . .Receive Status Change (significant in auto-mode only!)
A status change (receiver ready/receiver not ready) of the opposite station has been
detected in auto-mode. (i.e. the HSCX has received a RR/RNR supervisory frame
according to the HDLC protocol.) The current status can be read from the STAR
register (RRNR bit).
XPR. . .Transmit Pool Ready
A data block of up to 32 bytes can be written to the transmit FIFO.
TIN. . .Timer Interrupt
The internal timer and repeat counter has been expired. (See also description of TIMR
register!)
ICA … Interrupt of Channel A (Channel B only)
Indicates, that an interrupt is caused by channel A and the interrupt source(s) is (are)
indicated in the ISTA register of channel A (i.e. at least one bit of the ISTA register of
channel A is set).
Semiconductor Group
82