V23826-K305-C13 Datasheet, PDF (8/17 Pages) Infineon Technologies AG – Multimode 850 nm 1.0625 Gbit/s Fibre Channel 1.3 Gigabit Ethernet 1x9 Transceiver

V23826-K305-Cxx/Cxxx
Technical Data
Receiver Electro-Optical Characteristics
Parameter
Symbol
Sensitivity (Average Power)¹⁾
Saturation (Average Power)
Signal Detect Assert Level²⁾
Signal Detect Deassert Level³⁾
Signal Detect Hysteresis
Signal Detect Assert Time
Signal Detect Deassert Time
Output Low Voltage⁴⁾
Output High Voltage⁴⁾
Signal Detect Output
Voltage AC/AC TTL⁵⁾
Low
High
Data Output
Differential Voltage⁶⁾
P_IN
P_SAT
P_SDA
P_SDD
P_SDA
–P_SDD
t_ASS
t_DAS
V_OL–V_CC
V_OH–V_CC
V_SDL
V_SDH
V_DIFF
Output Data Rise/Fall Time,
20% - 80%
t_R, t_F
Return Loss of Receiver
A_RL
Power Dissipation
5 V P_Disr
3.3 V
min.
–30
–1950
–1100
2
0.5
12
Values
typ.
–20
–24
–27
3
max.
–17
0
–18
100
350
–1620
–720
0.5
0.8
1.23
375
0.63
0.68
0.30
0.42
Unit
dBm
dBm
dBm
dBm
dB
µs
µs
mV
mV
V
V
ps
dB
W
1) _{Minimum average optical power at which the BER is less than 1x10E–12 or lower. Measured with a 2}7_{–1 NRZ}
PRBS and ER = 9 dB. Output of multimode fiber 65 µm or 50 µm diameter.
2) _{An increase in optical power above the specified level will cause the Signal Detect output to switch from a low}
state to a high state.
3) _{A decrease in optical power below the specified level will cause the Signal Detect to change from a high state}
to a low state.
4) _{DC/DC, AC/DC for data. DC/DC, AC/DC, AC/AC PECL for SD. PECL compatible. Load is 50 Ω into VCC–2 V}
for data, 500 Ω to V_EE for Signal Detect. Measured under DC conditions. For dynamic measurements a
tolerance of 50 mV should be added. V_CC = 3.3 V/5 V. T_AMB = 25°C.
5) _{Max. output current}
high: –0.4 mA (drive current)
low: +2 mA (sink current).
6) _{AC/AC for data. Load 50 Ω to GND or 100 Ω differential. For dynamic measurement a tolerance of 50 mV}
should be added.
Data Sheet
8
2004-01-27