TLE8386-2EL Datasheet, PDF (8/32 Pages) Infineon Technologies AG – Basic Smart Boost Controller

TLE8386-2EL
General Product Characteristics
Absolute Maximum Ratings¹⁾
T_j = -40 °C to +150 °C; all voltages with respect to ground, positive current flowing into pin
(unless otherwise specified)
Pos.
Parameter
Symbol
Limit Values
Unit
Min.
Max.
ESD Susceptibility
4.1.22 ESD Resistivity to GND
V_ESD,HBM
-2
2
kV
4.1.23 ESD Resistivity to GND
V_ESD,CDM
-500
500
V
4.1.24 ESD Resistivity Pin 1, 7, 8, 14 (corner V_ESD,CDM,C -750
750
V
pins) to GND
1) Not subject to production test, specified by design.
2) ESD susceptibility, Human Body Model “HBM” according to EIA/JESD 22-A114B
3) ESD susceptibility, Charged Device Model “CDM” EIA/JESD22-C101 or ESDA STM5.3.1
Conditions
HBM²⁾
CDM³⁾
CDM³⁾
Note: Stresses above the ones listed here may cause permanent damage to the device. Exposure to absolute
maximum rating conditions for extended periods may affect device reliability.
Note: Integrated protection functions are designed to prevent IC destruction under fault conditions described in the
data sheet. Fault conditions are considered as “outside” normal operating range. Protection functions are
not designed for continuous repetitive operation.
4.2
Functional Range
Pos. Parameter
4.2.1 Supply Voltage Input
Symbol
V_IN
Limit Values
Min.
Max.
4.75
45
Unit Conditions
V
V_IVCC > V_IVCC,RTH,d
Note: Within the functional range the IC operates as described in the circuit description. The electrical
characteristics are specified within the conditions given in the related electrical characteristics table.
4.3
Thermal Resistance
Note: This thermal data was generated in accordance with JEDEC JESD51 standards. For more information, go
to www.jedec.org.
Pos. Parameter
Symbol
Limit Values
Unit Conditions
Min. Typ. Max.
4.3.1
4.3.2
4.3.3
4.3.4
Junction to Case¹⁾
Junction to Ambient^{1) 2)}
R_thJC
–
R_thJA
–
R_thJA
–
R_thJA
–
10
–
47
–
54
–
64
–
K/W –
K/W 2s2p
K/W 1s0p + 600 mm²
K/W 1s0p + 300 mm²
1) Not subject to production test, specified by design.
2) Specified R_thJA value is according to JEDEC 2s2p (JESD 51-7) + (JESD 51-5) and JEDEC 1s0p (JESD 51-3) + heatsink
area at natural convection on FR4 board;
Data Sheet
8
Rev. 1.0, 2010-10-25