TLE4966-2K Datasheet, PDF (8/14 Pages) Infineon Technologies AG – High Precision Hall Switch with two Outputs

TLE4966-2K
Maximum Ratings
2.3
Application Circuit
It is recommended to use a series resistor R_S with 200Ω and a capacitor of C_S = 4.7nF for protection against
overvoltage and transients on the supply line. Pull-up resistors R_L are required for the output pins Q₁ and Q₂.
V_S
R_S
V_DD ^{RL RL}
CS
Q₁
Q₂
GND
Figure 3 Application Circuit
3
Maximum Ratings
Table 2 Absolute Maximum Ratings
T_j = -40°C to 150°C
Parameter
Symbol
Limit Values Unit
min.
max.
Supply voltage
V_DD
-18
18
V
V_s
-18
24
V_s
-18
26
Supply current
I_DD
-50
50
mA
through protection
device
Output voltage
V_Q
-0.7
18
V
-0.7
26
Continuous output I_Q
-50
50
mA
current
Junction
temperature
T_j
–
–
–
–
155
°C
165
175
195
Storage
temperature
T_S
-40
150
°C
Magnetic flux
B
–
density
unlimited mT
Conditions
for 1 h, R_S ≥ 200 Ω
for 5 min, R_S ≥ 200 Ω
for 5 min @ 1.2 kΩ pull up
for 2000 h (not additive)
for 1000 h (not additive)
for 168 h (not additive)
for 3 x 1 h (additive)
Note: Stresses above those listed here may cause permanent damage to the device. Exposure to absolute
maximum rating conditions for extended periods may affect device reliability. Maximum ratings are absolute
ratings; exceeding only one of these values may cause irreversible damage to the integrated circuit.
Datasheet
8
Rev.1.0, 2010-06-28