ILD4071 Datasheet, PDF (8/25 Pages) Infineon Technologies AG – LED Driver for High Power LEDs

ILD4071
General Product Characteristics
4
General Product Characteristics
4.1
Absolute Maximum Ratings
Absolute Maximum Ratings¹⁾
T_j = -40 °C to +125 °C; all voltages with respect to ground (unless otherwise specified)
Pos.
Parameter
Symbol
Limit Values
Unit
Min.
Max.
Voltages
4.1.1
VREC (Pin 1)
Recirculation and Supply Input
V_REC
-0.3
45
V
4.1.2 ST (Pin 2)
V_ST
-0.3
45
V
Diagnostic Status Output Voltage
4.1.3
ST (Pin 2)
Diagnostic Status Current
I_ST
–
150
mA
4.1.4
EN (Pin 3)
Enable Input Voltage
V_EN
-0.3
45
V
4.1.5 SET (Pin 4)
V_SET
-0.3
6
V
Peak Current Adjust Input Voltage
4.1.6
PWMI (Pin 5)
PWM Input Voltage
V_PWMI -0.3
6
V
4.1.7
FREQ (Pin 6)
OFF-time Adjustment Input
V_FREQ -0.3
6
V
4.1.8
SW (Pin 8)
Switch Output
V_SW
-0.3
45
V
Temperatures
4.1.9 Junction Temperature
4.1.10 Storage Temperature
ESD Susceptibility
T_j
-40
T_stg
-55
150
°C
150
°C
4.1.11 ESD Resistivity all Pins to GND
V_ESD,HBM -2
2
kV
1) Not subject to production test, specified by design.
2) ESD susceptibility HBM according to EIA/JESD 22-A 114B
Conditions
–
–
–
–
–
–
–
–
–
–
HBM ²⁾
Note: Stresses above the ones listed here may cause permanent damage to the device. Exposure to absolute
maximum rating conditions for extended periods may affect device reliability.
Note: Integrated protection functions are designed to prevent IC destruction under fault conditions described in the
data sheet. Fault conditions are considered as “outside” normal operating range. Protection functions are
not designed for continuous repetitive operation.
Datasheet
8
Rev. 1.0, 2011-11-16