TC1762 Datasheet, PDF (74/114 Pages) Infineon Technologies AG – 32-Bit Single-Chip Microcontroller TriCore

TC1762
Preliminary
Electrical Parameters
Table 4-3 Operating Condition Parameters
Parameter
Symbol
Limit Unit Notes
Values
Conditions
Min. Max.
Inactive device pin current I_ID
(V_DD = V_DDP = 0)
External load capacitance C_L
SR -1
SR –
1
mA
See pF
DC
chara
cterist
ics
Voltage on all
power supply
pins V_DDx = 0
Depending on
pin class
1) Digital supply voltages applied to the TC1762 must be static regulated voltages which allow a typical voltage
swing of ±5%.
2) Voltage overshoot up to 1.7 V is permissible at Power-Up and PORST low, provided the pulse duration is less
than 100 µs and the cumulated summary of the pulses does not exceed 1 h.
3) Voltage overshoot to 4 V is permissible at Power-Up and PORST low, provided the pulse duration is less than
100 µs and the cumulated summary of the pulses does not exceed 1 h.
4) The TC1762 uses a static design, so the minimum operation frequency is 0 MHz. Due to test time restriction
no lower frequency boundary is tested, however.
5) The PLL jitter characteristics add to this value according to the application settings. See the PLL jitter
parameters.
6) Applicable for digital outputs.
7) See additional document “TC1796 Pin Reliability in Overload“ for overload current definitions.
Data Sheet
70
V1.0, 2008-04