V23826-H18-C366 Datasheet, PDF (7/14 Pages) Infineon Technologies AG – DC/DC (3.3V) Single Mode 622 MBd ATM/SDH/SONET 1x9 Transceiver Extended Temperature Range

V23826-H18-C366
Technical Data
Receiver Electro-Optical Characteristics
Parameter
Symbol
Limit Values
Unit
min.
typ.
max.
Sensitivity (Average Power)¹⁾
Saturation (Average Power)
Signal Detect Assert Level²⁾
Signal Detect Deassert Level³⁾
Signal Detect Hysteresis
Signal Detect Assert Time
Signal Detect Deassert Time
Output Low Voltage⁴⁾
Output High Voltage⁴⁾
Output Data Rise/Fall Time,
20%–80%
P_IN
P_SAT
P_SDA
P_SDD
P_SDA –
P_SDD
t_ASS
t_DAS
V_OL - V_CC
V_OH - V_CC
t_R, t_F
–8
–37
–38
–1950
–1025
-30
–31.4
–34.5
1.5
-28
dBm
–28
–29
dB
100
µs
350
–1620 mV
–720
375
ps
Return Loss of Receiver
A_RL
12
dB
1) _{Minimum average optical power at which the BER is less than 1x10}–12 _{or lower. Measured with a 2}23 _{– 1 NRZ}
PRBS as recommended by ANSI T1E1.2, SONET OC-3 and OC-12, and ITU-T G.957.
2) _{An increase in optical power of data signal above the specified level will cause the SIGNAL DETECT to switch}
from a Low state to a High state.
3) _{A decrease in optical power of data signal below the specified level will cause the SIGNAL DETECT to switch}
from a High state to a Low state.
4) _{DC/DC for data, DC/DC PECL for Signal Detect, PECL compatible. Load is 50 Ω into VCC – 2 V for data, 270 Ω}
(3.3 V) to V_EE for Signal Detect. Measured under DC conditions. For dynamic measurements a tolerance of
50 mV should be added. V_CC = 3.3 V. T_AMB = 25°C.
Data Sheet
7
2000-06-01