English
Language : 

IKCM20L60HD_15 Datasheet, PDF (5/16 Pages) Infineon Technologies AG – Control Integrated POwer System
CIPOS™ IKCM20L60HD
Pin Assignment
Pin Number
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
Pin Name
Pin Description
VS(U)
U-phase high side floating IC supply offset voltage
VB(U)
U-phase high side floating IC supply voltage
VS(V)
V-phase high side floating IC supply offset voltage
VB(V)
V-phase high side floating IC supply voltage
VS(W)
W-phase high side floating IC supply offset voltage
VB(W)
W-phase high side floating IC supply voltage
HIN(U)
U-phase high side gate driver input
HIN(V)
V-phase high side gate driver input
HIN(W) W-phase high side gate driver input
LIN(U)
U-phase low side gate driver input
LIN(V)
V-phase low side gate driver input
LIN(W)
W-phase low side gate driver input
VDD
Low side control supply
VFO
Fault output
ITRIP
Over current shutdown input
VSS
Low side control negative supply
NW
W-phase low side emitter
NV
V-phase low side emitter
NU
U-phase low side emitter
W
Motor W-phase output
V
Motor V-phase output
U
Motor U-phase output
P
Positive bus input voltage
NC
No Connection
Pin Description
HIN(U,V,W) and LIN(U,V,W) (Low side and high
side control pins, Pin 7 - 12)
These pins are positive logic and they are
responsible for the control of the integrated IGBT.
The Schmitt-trigger input thresholds of them are
such to guarantee LSTTL and CMOS compatibility
down to 3.3V controller outputs. Pull-down resistor
of about 5k is internally provided to pre-bias inputs
during supply start-up and a zener clamp is
provided for pin protection purposes. Input Schmitt-
trigger and noise filter provide beneficial noise
rejection to short input pulses.
The noise filter suppresses control pulses which are
below the filter time tFILIN. The filter acts according to
Figure 4.
HINx
LINx
VSS
 5k
CIPOS
Schmitt-Trigger
INPUT NOISE
FILTER
UZ=10.5V
SWITCH LEVEL
VIH; VIL
Figure 3: Input pin structure
a)
HIN
LIN
HO
LO
tFILIN
low
b)
HIN
LIN
HO
LO
tFILIN
high
Figure 4: Input filter timing diagram
Datasheet
5
Ver. 1.2, 2014-11-01