AUIRFR8405 Datasheet, PDF (5/12 Pages) International Rectifier – Advanced Process Technology, New Ultra Low On-Resistance

AUIRFR/U8405
10
1
D = 0.50
0.20
0.1
0.10
0.05
0.02
0.01
0.01
0.001
0.0001
1E-006
SINGLE PULSE
( THERMAL RESPONSE )
1E-005
0.0001
0.001
t1 , Rectangular Pulse Duration (sec)
Notes:
1. Duty Factor D = t1/t2
2. Peak Tj = P dm x Zthjc + Tc
0.01
0.1
Fig 13. Maximum Effective Transient Thermal Impedance, Junction-to-Case
1000
100
Duty Cycle = Single Pulse
0.01
Allowed avalanche Current vs avalanche
pulsewidth, tav, assuming Tj = 150°C and
Tstart =25°C (Single Pulse)
0.05
10
0.10
Allowed avalanche Current vs avalanche
pulsewidth, tav, assuming  j = 25°C and
Tstart = 150°C.
1
1.0E-06
1.0E-05
1.0E-04
tav (sec)
1.0E-03
1.0E-02
1.0E-01
Fig 14. Typical Avalanche Current Vs. Pulse width
250
TOP
Single Pulse
BOTTOM 1.0% Duty Cycle
200
ID = 90A
150
100
50
0
25 50 75 100 125 150 175
Notes on Repetitive Avalanche Curves , Figures 14, 15:
(For further info, see AN-1005 at www.infineon.com)
1. Avalanche failures assumption:
Purely a thermal phenomenon and failure occurs at a temperature far in
excess of Tjmax. This is validated for every part type.
2. Safe operation in Avalanche is allowed as long as Tjmax is not exceeded.
3. Equation below based on circuit and waveforms shown in Figures 22a, 22b.
4. PD (ave) = Average power dissipation per single avalanche pulse.
5. BV = Rated breakdown voltage (1.3 factor accounts for voltage increase
during avalanche).
6. Iav = Allowable avalanche current.
7. T = Allowable rise in junction temperature, not to exceed Tjmax (assumed as
25°C in Figure 13, 14).
tav = Average time in avalanche.
D = Duty cycle in avalanche = tav ·f
ZthJC(D, tav) = Transient thermal resistance, see Figures 13)
Starting TJ , Junction Temperature (°C)
Fig 15. Maximum Avalanche Energy Vs. Temperature
P_{D (ave)} = 1/2 ( 1.3·BV·I_av) = T/ Z_thJC
I_av = 2T/ [1.3·BV·Z_th]
E_{AS (AR)} = P_{D (ave)}·t_av
5
2015-10-12