TDA7210 Datasheet, PDF (45/52 Pages) Infineon Technologies AG – Wireless Components ASK/FSK Single Conversion Receiver

TDA7210
preliminary
Reference
Table 5-4 AC/DC Characteristics with T_AMB= -40°C ... + 85°C, V_CC = 4.5 ... 5.5 V
Parameter
Symbol
Limit Values
Unit Test Conditions /
min
typ
max
Notes
POWER DOWN MODE
Signal PDWN (PIN 27)
1 Powerdown Mode On
PWDN_ON 2.8
V_CC
V
2 Powerdown Mode Off
PWDN_Off
0
0.8
V
3 Start-up Time until valid
T_SU
signal is detected at IF
<1
ms depends on the
used crystal
VCO MULTIPLEXER
Signal FSEL (PIN 11)
1 f_RF range 434 MHz
V_FSEL
1.4
4²
V or open
2 f_RF range 869 MHz
V_FSEL
0
0.2
V
3 Output bias current
FSEL
I_FSEL
-110 -200
-340
µA FSEL tied to GND
L Item
PLL DIVIDER
Signal CSEL (PIN 16)
1 f_CRSTL range 6.xxMHz
V_CSEL
1.4
2 f_CRSTL range
13.xxMHz
V_CSEL
0
3 Input bias current
CSEL
I_CSEL
-3
-5
4²
V or open
0.2
V
-7
µA CSEL tied to GND
■ Not part of the production test - either verified by design or measured in an Infineon Evalboard as described in 2.
1) 2.8V is the voltage which is at least required that the LNA of a device is in high gain mode over the whole
RF-input level range. 3.3V is required that the LNA of each device is reliable in high gain mode over the whole
RF-input level range (considering also the production spread).
2) Maximum voltage in Power-On state is 4V, but in PDWN-state the maximum voltage is 2.8V.
Wireless Components
5 - 11
Data Sheet, December 2008