V23867 Datasheet, PDF (4/6 Pages) Infineon Technologies AG – SMCTM SB Connector Jumper

Application Note
V23867-+xx91-+yyy
Application Note
R20
relief
point
>=34
Dimensions in mm
Figure 1 Example of Board with PAROLI^® Modules and 4 SMC SB Connectors
Notes:
- The cable boot (drawn in white broken lines) is made of a soft plastic material which
allows it, on the one hand, to follow the cable bend movement in the channel nestling
against the cable jacket. But on the other hand it prevents the cable from a to small
bend radius.
- The bend of the connector housing and of the fiber ribbon inside is R = 20 mm. The
same value is applied for twist & bend when guiding the cable to the cable track.
- The small bend radius is only allowed assuming that there is no additional stress (e.g.
pull strain). Therefore the cable(s) should be relieved at a central relief point to avoid
damages in the fiber and in the connector/module receptacle due to pull forces higher
than allowed in the specification.
Data Sheet
4
2001-12-01