BTS3408G Datasheet, PDF (4/16 Pages) Infineon Technologies AG – Smart Dual Lowside Power Switch

HITFET^â BTS3408G
Circuit Description
Logic Supply
The logic is supplied with 4.5 up to 60 Volt by the V_S pin. If V_S falls below max. 4.5 Volts
the logic is shut down and the output stages are switched off.
Direct Inputs
ENA
The ENA/FREEZE input can be used to enable and/or to freeze the output control of the
IC or to cut off the complete IC.
By pulling the ENA input to low, i.e. applying a Voltage V_ENAL , the IC is in disable mode.
The power stages are switched off and the current consumption is reduced to I_S(stby).
By applying a Voltage V_ENAFZ , the IC is in FREEZE mode. The output signals will remain
in their former state. All input signals will be ignored.
By pulling the input to high, the IC is in Enable mode. All input signals are output.
The ENA - pin has an internal pull-down.
IN1 / IN2
Each output is independently controlled via the respective input pin. The input pins are
high active. If the common enable pin is high, the individual input signals are output. The
input pins have an internal pull-down.
Table 1
Functional Table
V_ENA
≤0.8V
Mode IN1 IN2 IN1(-1) IN2(-1) OUT1 OUT2 Comment
Disable X ¹⁾ X ¹⁾ X ¹⁾
X ¹⁾
L
L
all outputs OFF
1.2 .. 1.7V Freeze X ¹⁾ X ¹⁾ L
L
L
L
former output state
1.2 .. 1.7V Freeze X ¹⁾ X ¹⁾ L
H
L
H
former output state
1.2 .. 1.7V Freeze X ¹⁾ X ¹⁾ H
L
H
L
former output state
1.2 .. 1.7V Freeze X ¹⁾ X ¹⁾ H
H
H
H
former output state
≥2.0V
Enable L L X ¹⁾
X ¹⁾
L
L
input is output
≥2.0V
Enable L H X ¹⁾
X ¹⁾
L
H
input is output
≥2.0V
Enable H L X ¹⁾
X ¹⁾
H
L
input is output
≥2.0V
Enable H H X ¹⁾
X ¹⁾
H
H
input is output
1) _{X = not relevant}
Data Sheet V1.0
4
2002-11-14