English
Language : 

TDA5211 Datasheet, PDF (37/52 Pages) Infineon Technologies AG – ASK/FSK Single Conversion Receiver
TDA 5211
preliminary
Reference
5.1.3 AC/DC Characteristics at TAMB = 25°C
AC/DC characteristics involve the spread of values guaranteed within the spe-
cified voltage and ambient temperature range. Typical characteristics are the
median of the production. Currents flowing into the device are denoted as po-
sitive currents and vice versa.
The device performance parameters marked with s were measured on an
Infineon evaluation board as described in Section 5.2.
Table 5-3 AC/DC Characteristics with TA 25 °C, VVCC = 4.5 ... 5.5 V
Parameter
Symbol
Limit Values
min
typ
max
Supply
Supply Current
1 Supply current,
standby mode
IS PDWN
50
100
2 Supply current, device
ISF
operating in FSK mode
4.9
5.7
6.5
3 Supply current, device
ISA
operating in ASK mode
4.2
5
5.8
Unit Test Conditions
L Item
nA
Pin 27 (PDWN)
open or tied to 0 V
mA
Pin 11 (FSEL)
open, Pin 15
(MSEL) tied to GND
mA
Pin 11 (FSEL)
open, Pin 15
(MSEL) open
LNA
Signal Input LNI (PIN 3), VTHRES > 2.8V, high gain mode
1 Average Power Level
at BER = 2E-3
(Sensitivity)
RFin
-113
2 Average Power Level
at BER = 2E-3
(Sensitivity) FSK
RFin
-105
3 Input impedance,
fRF = 315 MHz
S11 LNA
0.895 / -25.5 deg
4 Input level @ 1dB C.P. P1dBLNA
-14
fRF=315 MHz
5 Input 3rd order intercept IIP3LNA
-10
point fRF = 315 MHz
6 LO signal feedthrough
at antenna port
LOLNI
-119
Signal Output LNO (PIN 6), VTHRES > 2.8V, high gain mode
1 Gain fRF = 315 MHz
S21 LNA
1.577 / 150.3 deg
2 Output impedance,
fRF = 315 MHz
S22 LNA
0.897 / -10.3 deg
dBm Manchester
encoded datarate s
4kBit, 280kHz IF
Bandwidth
dBm Manchester enc.
datarate 4kBit,
s
280kHz IF Bandw.,
± 50kHz pk. dev.
s
dBm
s
dBm fin = 315 & 317MHz s
dBm
s
s
s
Wireless Components
5-4
Specification, May 2001