BTS441R_09 Datasheet, PDF (3/15 Pages) Infineon Technologies AG – Smart Power High-Side-Switch One Channel: 20 mΩ

BTS441R
Maximum Ratings at Tj = 25 °C unless otherwise specified
Parameter
Symbol
Supply voltage (overvoltage protection see page 4)
Supply voltage for full short circuit protection
T_{j Start}=-40 ...+150°C
Load dump protection¹⁾ V_LoadDump = V_A + V_s, V_A = 13.5 V
R_I²⁾= 2 Ω, R_L= 0,5 Ω, t_d= 200 ms, IN= low or high
Load current (Short-circuit current, see page 5)
Operating temperature range
Storage temperature range
V_bb
V_bb
V_{Load dump3)}
I_L
T_j
T_stg
Power dissipation (DC) ; TC≤25°C
Maximal switchable inductance, single pulse
V_bb = 12V, T_j,start = 150°C, T_C = 150°C const.
(see diagram, p.7) I_L(ISO) = 21 A, RL= 0 Ω: E^4)AS=0.7J:
Electrostatic discharge capability (ESD)
IN:
(Human Body Model)
ST:
Out to all other pins shorted:
acc. MIL-STD883D, method 3015.7 and
ESD assn. std. S5.1-1993; R=1.5kΩ; C=100pF
Input voltage (DC)
Current through input pin (DC)
Current through status pin (DC)
see internal circuit diagrams page 7
P_tot
Z_L
V_ESD
V_IN
I_IN
I_ST
Thermal resistance
chip - case: R_thJC
junction - ambient (free air): ^RthJA
SMD version, device on pcb⁵⁾:
Values Unit
43 V
34 V
60 V
self-limited A
-40 ...+150 °C
-55 ...+150
125 W
2.1 mH
1.0 kV
4.0
8.0
-10 ... +16 V
±2.0 mA
±5.0
≤ 1 K/W
≤ 75
≤ 33
1) _{Supply voltages higher than Vbb(AZ) require an external current limit for the GND pin, e.g. with a 150 Ω}
resistor in the GND connection. A resistor for the protection of the input is integrated.
2) _{RI = internal resistance of the load dump test pulse generator}
3) _{VLoad dump is setup without the DUT connected to the generator per ISO 7637-1 and DIN 40839}
4) _{EAS is the maximum inductive switch off energy}
5) _{Device on 50mm*50mm*1.5mm epoxy PCB FR4 with 6cm}2 _{(one layer, 70μm thick) copper area for Vbb}
connection. PCB is vertical without blown air.
Data sheet
3
Rev. 1.1, 2009-01-30