V23832-T2531-M101 Datasheet, PDF (22/33 Pages) Infineon Technologies AG – PAROLI 2 Tx AC, 1.25 Gbit/s

V23832-T2531-M101
V23832-R511-M101
Technical Data
Receiver Electrical Characteristics
Parameter
Symbol
Values
Unit
min.
typ.
max.
Supply Current¹⁾
I_CC
Power Consumption^{1), 2)}
P
170
200
mA
+15 I_out +15 I_out
0.7
0.9
W
Data Output Rise/Fall Time³⁾
LVCMOS Output Voltage Low
LVCMOS Output Voltage High
LVCMOS Input Current
High/Low
t_R-DO,
t_F-DO
V_LVCMOSOL
V_LVCMOSOH 2500
I_LVCMOSI –100
250
ps
400
mV
mV
100
µA
LVCMOS Output Current High⁴⁾
LVCMOS Output Current Low⁵⁾
Total Jitter ^{6), 7), 8), 9), 10)}
I_LVCMOSOH
I_LVCMOSOL
TJ
0.5
mA
4.0
mA
0.33
UI
Deterministic Jitter^{6), 9), 11)}
DJ
0.08
UI
Channel-to-channel skew¹²⁾
t_CSK
100
ps
1) _{Typical value is measured at Tcase = 45°C and 3.3 V, maximum value is measured at Tcase = 80°C and 3.6 V.}
2) _{Calculated for Iout = 3 mA.}
3) _{Measured between 20% and 80% level. Maximum value is related to a maximum RC load time constant of}
t_RC = 150 ps.
4) _{Source current.}
5) _{Sink current.}
6) _{With no optical input jitter.}
7) _{Measured with an optical input power of 3 dB above minimum receiver sensitivity.}
8) _{Unused channels shall be terminated by 50 Ω.}
9) _{UI (Unit Interval) is equal to the length of one bit. For example, 2.72 Gbit/s corresponds to 368 ps.}
10) _{The Total Jitter (TJ) is the sum from Random Jitter (RJ) and Deterministic Jitter (DJ) according to:}
TJ = RJ (14 Sigma value) + DJ.
The TJ is specified at a BER of 10^–12 from TP3 to TP4 according to IEEE 802.3, sec. 38.5.
The RJ is measured at the 50% level of the optical signal as the mean of the rising and falling edge RJ
measurement value.
11) _{The DJ consists of Duty Cycle Distortion and Data Dependent Jitter and is measured according to IEEE 802.3}
using a K28.5 pattern.
12) _{With input channel-to-channel skew 0 ps.}
Data Sheet
22
2003-11-19