V23833-F0105-B001 Datasheet, PDF (2/2 Pages) Infineon Technologies AG – 10 Gigabit XFP SerialHot-Pluggable Transceiver

Products
Ordering code
V23833-F0005-B101
V23833-F0105-B001
Accessories
Ordering code
V23833-F9909-Z001
a
Wave length
850 nm
1310 nm
Reach Optical connect
300 m*
LC
10 km
LC
* Using 50 µm multi-mode fiber with 2000 MHz*km bandwidth
Product
XFP evaluation board kit
Description
Test board with 30-Pin XFP connector and cage
XFP transceiver mechanical package [mm]
XFP transceiver block diagram
Vcc
ASIC
XFI
9.95-11.08 Gbit/s
SerDes/PHY
Hot swap control
Tx Rx timer
Rx CDR
2 wire
Control &
interface data management
Laser 10 G
driver laser
PIN + TIA/LA
9.95-11.08
Gbit/s
30-pin edge
connector
For more information, please contact:
Infineon Technologies
North America (CA):
Irene Yan
Phone: [phone]
[e-mail]
Europe (Germany):
Angela Scholl
Phone: [phone]
[e-mail]
Asia (Hong Kong):
Owen Chui
Phone: [phone]
[e-mail]
Japan (Tokyo):
Kunikazu Watanabe
Phone: [phone]
[e-mail]
Edition September 2003
Published by Infineon Technologies AG,
St.-Martin-Straße 53,
D-81669 München
© Infineon Technologies AG 2003.
All Rights Reserved.
Please note:
The information herein describes certain components and shall
not be considered as a guarantee of characteristics.
Terms of delivery and rights to technical change reserved.
We hereby disclaim any and all warranties, including but not
limited to warranties of non-infringement regarding circuits,
descriptions and charts stated herein.
Infineon Technologies is an approved CECC manufacturer.
Information
For further information on technology, delivery terms and
conditions and prices, please contact your nearest Infineon
Technologies office in Germany or our Infineon Technologies
representatives worldwide (www.infineon.com).
Warnings
Due to technical requirements, components may contain dangerous substances.
For information on the types in question please contact your nearest Infineon
Technologies office.
Infineon Technologies components may only be used in life-support devices
or systems with the express written approval of Infineon Technologies if a
failure of such components can reasonably be expected to cause the failure
of that life-support device or system, or to affect the safety or effectiveness
of that device or system. Life-support devices or systems are intended to be
implanted in the human body, or to support and/or maintain and sustain
and/or protect human life. If they fail, it is reasonable to assume that the
health of the user or other persons may be endangered.
Order no. B159-H8165-G1-X-7600
Printed in Germany
PS 09032.