BTS612N1_13 Datasheet, PDF (2/14 Pages) Infineon Technologies AG – Fast demagnetization of inductive loads

BTS612N1
Pin
Symbol
Function
1
OUT1 (Load, L) Output 1, protected high-side power output of channel 1
2
GND
Logic ground
3
IN1
Input 1, activates channel 1 in case of logical high signal
4
Vbb
5
ST
Positive power supply voltage,
the tab is shorted to this pin
Diagnostic feedback: open drain, low on failure
6
IN2
Input 2, activates channel 2 in case of logical high signal
7
OUT2 (Load, L) Output 2, protected high-side power output of channel 2
Maximum Ratings at Tj = 25 °C unless otherwise specified
Parameter
Symbol
Supply voltage (overvoltage protection see page 4)
V_bb
Supply voltage for short circuit protection
V_bb
T_{j Start}=-40 ...+150°C
Load dump protection²⁾ V_LoadDump = U_A + V_s, U_A = 13.5 V V_{Load dump}⁴⁾
R_I³⁾= 2 , R_L= 5.3 , t_d= 200 ms, IN= low or high
Load current (Short circuit current, see page 5)
I_L
Operating temperature range
T_j
Storage temperature range
T_stg
Power dissipation (DC), T_C  25 °C
P_tot
Inductive load switch-off energy dissipation, single pulse
V_bb = 12V, T_j,start = 150°C, T_C = 150°C const.
one channel, I_L = 2.3 A, Z_L = 89 mH, 0 : E_AS
both channels parallel, I_L = 4.4 A, Z_L = 47 mH, 0 :
see diagrams on page 9
Electrostatic discharge capability (ESD)
IN: V_ESD
(Human Body Model)
all other pins:
acc. MIL-STD883D, method 3015.7 and ESD assn. std. S5.1-1993
Input voltage (DC)
V_IN
Current through input pin (DC)
I_IN
Current through status pin (DC)
I_ST
see internal circuit diagrams page 7
Values Unit
43 V
34 V
60 V
self-limited A
-40 ...+150 °C
-55 ...+150
36 W
290 mJ
580
1.0 kV
2.0
-10 ... +16 V
2.0 mA
5.0
2_{) Supply voltages higher than Vbb(AZ) require an external current limit for the GND and status pins, e.g. with a}
150  resistor in the GND connection and a 15 k resistor in series with the status pin. A resistor for the
protection of the input is integrated.
3_{) RI = internal resistance of the load dump test pulse generator}
4_{) VLoad dump is setup without the DUT connected to the generator per ISO 7637-1 and DIN 40839}
Data Sheet
2
2013-10-11