TLE7189QK_16 Datasheet, PDF (11/29 Pages) Infineon Technologies AG – 3-Phase Bridge Driver IC

TLE7189QK
General Product Characteristics
4.3
Table 1
Default State of Inputs
Default State of Inputs
Characteristic
Default state of ILx (if ILx left open -pull down)
Default state of IHx (if IHx left open - pull up)
Default state of ENA (if ENA left open - pull down)
Default state of VCT (if VCT left open - pull up)
Default state of INH (if INH left open - pull down)
Default state of SCDL (if SCDL left open - internal
voltage divider)
Default State of sense amplifier output V_OX
(ISPx=ISNx=0V)
Status of the Device and the Outputs when
ENA=INH=high & VCT=low¹⁾
1) No special start up procedure is required
State
Low
High
Low
High
Low
Typ. 1.4V
Remark
Low side MOSFETs off
High side MOSFETs off
Device/outputs disabled
Device/outputs disabled
Sleep mode, I_Q < 30 µA
–
Zero ampere equivalent –
Device active and outputs 5.5....28V; No VCC check
functional
failure
Note: The load condition “C=22nF; R_Load=1Ω” in the paragraph “Electrical characteristics / Dynamic characteristic”
means that R_Load is connected between the output Gxx and the positive terminal of the C. The negative
terminal of the C is connected to GND and the corresponding Sxx. The voltage is measured at the positive
terminal of the C.
Note: Within the functional range the IC operates as described in the circuit description. The electrical
characteristics are specified within the conditions given in the related electrical characteristics table.
Data Sheet
11
Rev. 2.2, 2016-01-28