V23848-C18-C56 Datasheet, PDF (10/30 Pages) Infineon Technologies AG – iSFP-Intelligent Small Form-factor Pluggable SONET OC-3 IR-1 / SDH STM S-1.1 Multirate Applications up to 155 Mbit/s

V23848-C18-C56
V23848-C19-C56
Technical Data
Optical Characteristics (V_CC = 2.97 V to 3.63 V, T_C = –40°C to 85°C)
Parameter
Symbol
Values
Unit
min.
typ.
max.
Transmitter
Launched Power (Average)¹⁾ P_O
–15
Extinction Ratio (Dynamic)
ER
8.2
–8
dBm
dB
Center Wavelength
Spectral Width (rms)
Tx Disable Laser Output Power
Optical Eye Mask²⁾
λ_C
σ_I
P_O-TxDis
1270
1355
2.5
–50
According to standards
nm
nm
dBm
Jitter Generation (pk-pk)³⁾
Jitter Generation (rms)³⁾
Rise Time⁴⁾
Fall Time⁴⁾
Receiver⁵⁾
J_{pk-pk Tx}
J_{rms Tx}
t_R-Tx
t_F-Tx
0.033
0.001
40
155
0.045 UI
0.0025 UI
ps
ps
Saturation (Average Power)⁶⁾ P_SAT
–8
Sensitivity (Average Power)⁷⁾ P_IN
@ 155 Mbit/s
@ 125 Mbit/s
@ 10 Mbit/s⁸⁾
dBm
dBm
–32
–28
–32
–28
–35
–28
LOS Assert Level⁹⁾
LOS Deassert Level⁹⁾
LOS Hysteresis⁹⁾
Input Center Wavelength
P_LOSA
–39
P_LOSD
P_LOSA
0.5
3
–P_LOSD
λ_C
1260
–30
1580
dBm
dBm
dB
nm
1) _{Into single mode fiber, 9 µm diameter.}
2) _{Transmitter eye is according to ITU-T G.957 S-1.1 and SONET OC-3 IR-1. Measured with 10% eye mask}
margin.
3) _{The transceiver is specified to meet the SONET/SDH Jitter performance as outlined in ITU-T G.958 and}
Telcordia GR-253. Jitter Generation is defined as the amount of jitter that is generated by the transceiver. The
Jitter Generation specifications are referenced to the optical OC-3 signals. If no or minimum jitter is applied to
the electrical inputs of the transmitter, then Jitter Generation can simply be defined as the amount of jitter on
the Tx optical output. The SONET specifications for Jitter Generation are 0.01 UI rms, maximum and 0.1 UI
pk-pk, maximum. For SDH, 10 mUI rms, maximum. Both are measured with a 12 kHz - 1.3 MHz filter in line.
A UI is a Unit Interval, which is equivalent to one bit slot.
4) _{Values are 20% - 80%, filtered and measured at nominal data rate.}
5) _{Receiver characteristics are measured with a worst case reference laser.}
6) _{At 9 dB Extinction Ratio of the incoming signal.}
Data Sheet
10
2004-06-25