TLE4976-2K Datasheet, PDF (10/16 Pages) Infineon Technologies AG – Hall Effect Switch with Current Interface

3.2
Absolute Maximum Ratings
TLE4976-2K
Specification
Table 2 Absolute Maximum Rating Parameters
Parameter
Symbol
Limit Values Unit
Min.
Max.
Supply voltage
V_S
– 18
18
V
– 18
24
– 18
26
Supply current through
I_S
protection device
– 50
+50
mA
Junction temperature
T_j
–
155
°C
–
165
–
175
–
195
Storage temperature
T_S
Magnetic flux density
B
– 40
150
°C
–
unlimited mT
Note / Test Condition
for 1h, R_S+R_L > 75Ω
for 5min, R_S+R_L > 75Ω
for 2000h (not additive)
for 1000h (not additive)
for 168h (not additive)
for 3 x 1h (additive)
Attention: Stresses above the max. values listed here may cause permanent damage to the device.
Exposure to absolute maximum rating conditions for extended periods may affect device
reliability. Maximum ratings are absolute ratings; exceeding only one of these values may
cause irreversible damage to the integrated circuit.
Table 3 ESD Protection¹⁾
Parameter
Symbol
Limit Values Unit Note / Test Condition
Min.
Max.
ESD Voltage
V_ESD
±8
kV HBM, R = 1.5kΩ,
C = 100pF
T_A = 25°C
1) Human Body Model (HBM) tests according to: EOS/ESD Association Standard S5.1-1993 and Mil. Std. 883D method
3015.7
3.3
Operating Range
The following operating conditions must not be exceeded in order to ensure correct operation of the Hall Effect
Switch.
All parameters specified in the following sections refer to these operating conditions unless otherwise mentioned.
Table 4 Operating Conditions Parameters
Parameter
Symbol
Values
Unit Note / Test Condition
Min. Typ. Max.
Supply voltage
V_S
3
3
Junction temperature
T_j
- 40
18
V
24
150 °C
175
for 5 min, R_S+R_L > 100Ω
for 168h
Data Sheet
8
Rev. 1.2, 2010-08-05