1EDI05I12AF_15 Datasheet, PDF (10/22 Pages) Infineon Technologies AG – Separate output variant for IGBT

1EDI EiceDRIVER™ Compact
Separate output variant for IGBT
Pin Configuration and Functionality
3
Pin Configuration and Functionality
3.1
Pin Configuration
Table 1 Pin Configuration
Pin No. Name
Function
1
VCC1
Positive Logic Supply
2
IN+
Non-Inverted Driver Input (active high)
3
IN-
Inverted Driver Input (active low)
4
GND1
Logic Ground
5
VCC2
Positive Power Supply Output Side
6
OUT+
Driver Source Output
7
OUT-
Driver Sink Output
8
GND2
Power Ground
1
VCC1
2
IN+
3
IN-
4
GND1
Figure 3 PG-DSO-8-51 (top view)
3.2
Pin Functionality
GND2
8
OUT-
7
OUT+
6
VCC2
5
VCC1
Logic Input supply voltage of 3.3 V up to 15 V wide operating range.
IN+ Non Inverting Driver Input
IN+ non-inverted control signal for driver output if IN- is set to low. (Output sourcing active at IN+ = high and
IN- = low)
Due to internal filtering a minimum pulse width is defined to ensure robustness against noise at IN+. An internal
weak pull-down-resistor favors off-state.
Data Sheet
10
Rev. 2.0, 2014-11-10