ILC705 Datasheet, PDF (3/5 Pages) Impala Linear Corporation – MP SUPERVISORY CIRCUIT

mP Supervisory Circuit
Pin Functions
Pin
Name
MR
Vcc
GND
PFI
PFO
WDI
N/C
RESET
WDO
RESET
Pin Number
ILC705 ILC707
ILC706 ILC708
1
1
2
2
3
3
4
4
5
5
6
N/A
N/A
6
7
7
8
N/A
N/A
8
Description
Manual reset input. MR forces RESET to assert when pulled below 0.8V.
An internal pull-up current of 250 mA on this input forces it high when
left floating. This input can also be driven from TTL or CMOS logic.
Power supply input, 5V.
Ground pin, 0 V reference.
Power fail input. Internally connected to the power fail comparator, which
is referenced to 1.25V. The power fail output (PFO) remains high if PFI
is above 1.25V. PFI should be connected to GND or V_OUT if the power
fail comparator is not used.
Power fail output. The power fail comparator is independent of all other
functions on this device.
Watchdog input. The WDI input monitors microprocessor activity, an
internal watchdog timer resets itself with each transition on the watchdog
input. If the WDI pin is held high or low for longer than the watchdog
timeout period, WDO is forced to active low. The watchdog function can
be disabled by floating the WDI pin.
No Connect.
RESET output. RESET is asserted if either V_CC goes below the reset
threshold or by a low signal on the manual reset input (MR). RESET
remains asserted for one reset timeout period (200ms) after V_CC
exceeds the reset threshold or after the manual reset pin transitions from
low to high. The watchdog timer will not assert RESET unless WDO is
connected to MR.
Watchdog timer output. The watchdog timer resets itself with each
transition on the watchdog input. If the WDI pin is held high or low for
longer than the watchdog timeout period, WDO is forced low. WDO will
also be forced low if V_CC is below the reset threshold and will remain low
until V_CC returns to a valid level.
RESET output. RESET is the compliment of RESET and is asserted if
either V_CC goes below the reset threshold or by a low signal on the
manual reset input (MR). RESET is suitable for microprocessors
systems that use an active high reset.
Impala Linear Corporation
ILC705-708 1.0
[phone] www.impalalinear.com
Sept 1999 3