IW4016B Datasheet, PDF (5/10 Pages) IK Semicon Co., Ltd – Quad Bilateral Switch

IW4016B
AC Electrical Characteristics ^(continue)
T_A = 25°C, t_r = t_f = 20 ns and V_SS = 0V unless otherwise specified
Parameter,
Units
Harmonic Factor, %
Frequency Response –
Switch “ON”
(Frequency at -3dB),
MHz
Frequency Response –
Switch “OFF”
(Frequency at -50dB),
MHz
Conditions,
Symbol
Units
V_IL,
V_IH,
I_O, V_DD,
V
V mA V
Kh
V_C=5 V, V_SS=-5 V, 5.0
V_IS=5 V, R_L=10 kOhm,
f_IS=1 кГц
-55°С
Min Max
--
Limits
+125°С
Min Max
--
+25°С
Min Max
0.4*
BW
V_C=5 V, V_SS=-5 V, 5.0 -
-
-
-
V_IS=5 V, R_L=1 kOhm,
C_L=50 pF,
t_LH=t_HL≤20 nsec
(Figure 4)
f₁
V_C=5 V, V_SS=-5 V, 5.0 -
-
-
-
V_IS=5 V, R_L=1 kOhm,
C_L=50 pF,
t_LH=t_HL≤20 nsec
(Figure 4)
40*
1.25*
Crosstalk Between Any
f₂
Two Swithes
(Frequency at -50dB),
MHz
(Figure 5)
5.0 - - - -
0.9*
Switching Frequency,
MHz
f_S
V_C=10 V, V_SS=GND, 10 -
-
-
-
10*
V_IS=10 V, R_L=1 kOhm,
C_L=50 pF,
t_LH=t_HL≤20 nsec
V_OS=1/2 V_OS under
frequency 1 kHz
Propagation Delay Time
Signal Input to Signal
Output, nsec
* Typical value
t_PHL
(t_PLH)
t_LH=t_HL≤20nsec,
C_L=50 pF
R_L=200 kOhm
5.0 - 70 - 200 - 100
10 - 40 - 80 - 40
15 - 30 - 60 - 30
Note 4: AC Parameters are guaranteed by DC correlated testing.
Note 5: These devices should not be connected to circuits with the power “ON”.
Note 6: In all cases, there is approximately 5 pF of probe and jig capacitance on the output; however, this capacitance is included in C_L wherever it is speci-
fied.
Note 7: V_IS is the voltage at the in/out pin and V_OS is the voltage at the out/in pin. V_C is the voltage at the control input.
Rev. 00