IL33091A Datasheet, PDF (3/5 Pages) IK Semicon Co., Ltd – Powerful High-grade FET driver

IL33091A
Тable of electrical parameters .
Electrical parameters of microcircuits IL33091AN, IL33091AD
Name of parameter,
unit of measurement
Symbol
Mode of measurement
standard
note
min
max
consumption current, mА
Icc
Vin = 0 V:
-
0,3
2
Vin=5,0 V (Rx=100 kОhm):
6,0
Limitation value of supply voltage on
Vz
29,0
35,0
3
pin Vcc (pin 05), V
output voltage range on pin »Gate» (pin
V_GS
04) relatively voltage of power supply
8,0
15,0
-
source Vcc, V
current on pin »Gate» (pin 04), µА
I_G
V_G =Vcc
30
400
-
output voltage of saturation on
pin»Gate» (pin 04), V
V_G(sat)
I_G =10µА
0
1,4
-
voltage on pin »Gate» in mode of load
V_GC
short circuit (pin 06), V
6,4
7,7
4
Threshold voltage on input »Input»
V_IL
(pin 07), V
V_IH
input current of pin »Input» (pin 07), µ
Iin
Vin=5,0 V
-
1,5
-
3,5
-
-
250
-
А
current coefficient of timer (pin 08), µ
А/V²
К
Rx=100 kОhm, Vт=0, V_DC=1,0 0,7
V
1,5
5
threshold voltage of synchronization
(pin 08), V
lower level
V_TL
upper level
V_TH
0,4
1,2
-
4,3
5,2
current on pin »» (pin 06), µА
I_OL
I_OH
Voltage of saturation on pin»» (pin
V_OL
06), V
V_F =5,0 V
V_F =0
I_F =500 µА
500
-
-
-
0,1
-
0,8
-
Note
1 .Standards for electrical parameters of table , unless otherwise noted , are given for conditions :
7,0 V ≤ Vcc ≤ 24 V; -40°С ≤ Тa ≤125°С.
2 .Measure total consumption current on pins 02 and 05 of microcircuit (when resistor is Rx=100 kОhm, connected
to pin 02, and resistor with the value of 45 kОhm, connected to pin 06).
3 . Protection of device from short-term voltage surge on power line at the expense of internal circuit of
semiconductor stabilitrons.
4. Measure voltage relatively pin «SRC» in shorted load mode , when voltage on load approximately will make less
than 1В in НУ relatively potential «general». Mode of measurements , residual stress on load of short-circuit mode are to
be specified in the course of development basing on the reference dependence reading results for temperature range.
5 Current coefficient of timer is a constant (coefficient )of proportionality of voltage into current conversion, used to
check V_DS voltage, formed on field transistor.
For microcircuit IL33091AN, arranged in 8-pin plastic DIP-package of MS-001BA type, Rtja is 100 °С/W; For
microcircuit IL33091AD – arranged in 8-pin plastic SO-package of MS-012AA MC33091AD type, Rtja is 145 °С/W.
permissible value of static potential value is 2000 V (human body model).
Nominal block diagram and IC connection circuit
3