IL393_11 Datasheet, PDF (2/5 Pages) IK Semicon Co., Ltd – Low Power Low Offset Voltage Dual Comparators

I L 393
MAXIMUM RATINGS^*
Symbol
Parameter
Value
Unit
V_CC Power Supply Voltages
Single Supply
Split Supplies
36
V
±18
V_IDR Input Differential Voltage Range
36
V
V_ICR Input Common Mode Voltage Range (1)
-0.3 to V_CC
V
I_SC Output Short Circuit to Ground
Continuous
I_IN
Input Current, per pin (2)
50
mA
T_J
Junction Temperature
Plastic Packages
150
°C
Tstg Storage Temperature
-65 to +150
°C
T_L
Lead Temperature, 1mm from Case for 10
Seconds
260
°C
P_D
Power Dissipation @T_A=25°C
Plastic Package
Derate above 25°C
570
mW
5.7
mW/°C
* Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device.
These are stress ratings only and functional operation of the device at these or any other conditions beyond those
indicated under “recommended operating conditions” is not implied.
Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
Functional operation should be restricted to the Recommended Operating Conditions.
Notes:
1. Split Power Supplies.
2. V_IN<-0.3V. This input current will only exist when voltage at any of the input leads is driven negative.
RECOMMENDED OPERATING CONDITIONS
Symbol
Parameter
V_CC
DC Supply Voltage
T_A
Operating Temperature, All Package Types
Min
Max
Unit
±2.5 ±15 or
V
or 5.0 30
-40
+85
°C
This device contains protection circuitry to guard against damage due to high static voltages or
electric fields. However, precautions must be taken to avoid applications of any voltage higher than
maximum rated voltages to this high-impedance circuit. For proper operation, V_IN and V_OUT should be
constrained to the range GND≤(V_IN or V_OUT)≤V_CC.
Unused inputs must always be tied to an appropriate logic voltage level (e.g., either GND or V_CC). Unused
outputs must be left open.
January 2011, Ver.03