ICS853S54I_17 Datasheet, PDF (7/21 Pages) Integrated Device Technology – Dual 2:1, 1:2 Differential-to-LVPECL/ECL Multiplexer

ICS853S54I Data Sheet
DUAL 2:1, 1:2 DIFFERENTIAL-TO-LVPECL/ECL MULTIPLEXER
Application Information
Wiring the Differential Input to Accept Single Ended Levels
Figure 1 shows how the differential input can be wired to accept
single ended levels. The reference voltage V_REF = V_CC/2 is
generated by the bias resistors R1, R2 and C1. This bias circuit
should be located as close as possible to the input pin. The ratio of
R1 and R2 might need to be adjusted to position the V_REF in the
center of the input voltage swing. For example, if the input clock
swing is only 2.5V and V_CC = 3.3V, V_REF should be 1.25V and
R2/R1 = 0.609.
Single Ended Clock Input
V_REF
C1
0.1u
VCC
R1
1K
CLKx
nCLKx
R2
1K
Figure 1. Single-Ended Signal Driving Differential Input
Recommendations for Unused Input and Output Pins
Inputs:
LVCMOS Control Pins
All control pins have internal pulldowns; additional resistance is not
required but can be added for additional protection. A 1k resistor
can be used.
PCLK/nPCLK Inputs
For applications not requiring the use of the differential input, both
PCLK and nPCLK can be left floating. Though not required, but for
additional protection, a 1k resistor can be tied from PCLK to
ground.
Outputs:
LVPECL Outputs
All unused LVPECL outputs can be left floating. We recommend that
there is no trace attached. Both sides of the differential output pair
should either be left floating or terminated.
ICS853S54AKI May 27, 2017
7
©2017 Integrated Device Technology, Inc.