8308I Datasheet, PDF (5/14 Pages) Integrated Device Technology – 8:1, Single-Ended Multiplexer

83058 Datasheet
TABLE 5B. AC CHARACTERISTICS, V = 3.3V ± 5%, V = 2.5V ± 5%, TA = -40°C TO 85°C
DD
DDO
Symbol Parameter
Test Conditions
Minimum Typical Maximum
f
MAX
tp
LH
tp
HL
tsk(i)
Output Frequency
Propagation Delay, Low to High; NOTE 1
Propagation Delay, High to Low; NOTE 1
Input Skew; NOTE 2
250
2.0
2.5
3.1
2.6
2.8
3.0
45
150
Buffer Additive Phase Jitter, RMS;
tjit
refer to Additive Phase Jitter Section;
NOTE 3
155.52MHz,
(12kHz to 20MHz)
0.14
tsk(pp) Part-to-Part Skew; NOTE 2, 4
400
t /t
RF
odc
Output Rise/Fall Time
Output Duty Cycle
20% to 80%
50
500
45
55
MUX MUX Isolation
ISOL
@ 100MHz
45
NOTE 1: Measured from V /2 of the input to V /2 of the output.
DD
DDO
NOTE 2: This parameter is defined in accordance with JEDEC Standard 65.
NOTE 3: Driving only one input clock.
NOTE 4: Defined as skew between outputs on different devices operating a the same supply voltages and
with equal load conditions. Using the same type of input on each device, the output is measured at V /2.
DDO
Units
MHz
ns
ns
ps
ps
ps
ps
%
dB
TABLE 5C. AC CHARACTERISTICS, V = 3.3V ± 5%, V = 1.8V ± 5%, TA = -40°C TO 85°C
DD
DDO
Symbol Parameter
Test Conditions
Minimum Typical Maximum
f
MAX
tp
LH
tp
HL
tsk(i)
Output Frequency
Propagation Delay, Low to High; NOTE 1
Propagation Delay, High to Low; NOTE 1
Input Skew; NOTE 2
250
2.3
2.9
3.8
2.8
3.3
3.8
50
150
Buffer Additive Phase Jitter, RMS;
tjit
refer to Additive Phase Jitter Section;
NOTE 3
155.52MHz,
(12kHz to 20MHz)
0.16
tsk(pp) Part-to-Part Skew; NOTE 2, 4
475
t /t
RF
odc
Output Rise/Fall Time
Output Duty Cycle
20% to 80%
100
700
45
55
MUX MUX Isolation
ISOL
@ 100MHz
45
NOTE 1: Measured from V /2 of the input to V /2 of the output.
DD
DDO
NOTE 2: This parameter is defined in accordance with JEDEC Standard 65.
NOTE 3: Driving only one input clock.
NOTE 4: Defined as skew between outputs on different devices operating a the same supply voltages and
with equal load conditions. Using the same type of input on each device, the output is measured at V /2.
DDO
Units
MHz
ns
ns
ps
ps
ps
ps
%
dB
©2015 Integrated Device Technology, Inc
5
December 15, 2015