5P49V5935_17 Datasheet, PDF (13/33 Pages) Integrated Device Technology – Programmable Clock Generator

5P49V5935 DATASHEET
Table 19:Electrical Characteristics – DIF 0.7V Low Power HCSL Differential Outputs
(V_DDO = 3.3V±5%, 2.5V±5%, TA = -40°C to +85°C)
Symbol Parameter
Conditions
Min
Typ
Max Units Notes
dV/dt Slew Rate
Scope averaging on
1
4
V/ns 1,2,3
Δ^dV/dt
VHIGH
VLOW
Slew Rate
Voltage High
Voltage Low
Scope averaging on
Statistical measurement on single-ended
signal using oscilloscope math function
660
(Scope averaging ON)
-150
20
%
1,2,3
850
mV 1,6,7
150
mV
1,6
VMAX
VMIN
Maximum Voltage
Minimum Voltage
Measurement on single-ended signal using
absolute value (Scope averaging off)
-300
1150
mV
1
mV
1
VSWING Voltage Swing
Scope averaging off
300
mV 1,2,6
VCROSS Crossing Voltage Value Scope averaging off
250
550
mV 1,4,6
Δ^VCROSS Crossing Voltage variation ^{Scope averaging off}
140
mV
1,5
1. Guaranteed by design and characterization. Not 100% tested in production
2. Measured from differential waveform.
3. Slew rate is measured through the V_SWING voltage range centered around differential 0V. This results in a +/-150mV window around
differential 0V.
4. V_CROSS is defined as voltage where Clock = Clock# measured on a component test board and only applies to the differential rising edge
(i.e. Clock rising and Clock# falling).
5. The total variation of all V_CROSS measurements in any particular system. Note that this is a subset of V_CROSS min/max (V_CROSS absolute)
allowed. The intent is to limit V_CROSS induced modulation by setting V_CROSS to be smaller than V_CROSS absolute.
6. Measured from single-ended waveform.
7. Measured with scope averaging off, using statistics function. Variation is difference between min. and max.
MARCH 10, 2017
13
PROGRAMMABLE CLOCK GENERATOR