|
IDTHS221P10 Datasheet, PDF (1/11 Pages) Integrated Device Technology – HYBRID SWITCH WITH NEGATIVE SIGNAL HANDLING | |||
|
HYBRID SWITCH WITH NEGATIVE SIGNAL HANDLING
DATASHEET
IDTHS221P10
Description
The IDTHS221P10 is a high-performance hybrid switch
device, combined with hybrid low distortion audio and USB
2.0 high speed data (480 Mbps) signal switches, and
analog switches. When operated with a 1.8 V single supply,
this high performance switch allows audio signal swings
below-ground, allowing the use of a common USB and
audio headphone connector in personal media players and
other portable battery powered devices.
The IDTHS221P10 logic SEL control pin is 1.8 V
compatible which allows for control via a standard
µcontroller. With a VDD voltage in the range of 1.7 V to 1.95
V, the device can pass USB 3 V signal sources in the
portable device, with up to 5.5 V tolerant on USB and COM
signal pins. The part has an audio enable control pin to
open all the switches and put the part in a low power state.
The IDTHS221P10 is available in a small 10-pin µMLP
package.
Features
⢠+1.7 V to +1.95 V single-supply operation (VDDx)
⢠Low distortion negative signal handling capability with
Ron less than 2 ohm for Audio signal
⢠Control pin to open all switches and enter low power state
⢠Cross-talk audio channels (20 Hz to 20 kHz): -110dB
⢠-3dB bandwidth USB switches: 700 MHz
⢠Available in µMLP packages â RoHS compliant
⢠Compliant with USB 2.0 short circuit requirements
without additional external components
⢠Power off protection on common D+/R, D-/L ports
Applications
⢠MP3 and other personal media players
⢠PDAâs
⢠Audio/USB Switching
⢠Cellular and mobile phones
Block Diagram
SEL
D+
R
D-
L
Control
Circuit
RCOM+
RCOM-
VDDD VDDA
GND
COM+
COM-
IDT⢠HYBRID SWITCH WITH NEGATIVE SIGNAL HANDLING
1
IDTHS221P10 REV F 112108
|
▷ |