IDT70V261S_12 Datasheet, PDF (1/17 Pages) Integrated Device Technology – HIGH-SPEED 3.3V 16K x 16 DUAL-PORT STATIC RAM

HIGH-SPEED 3.3V
16K x 16 DUAL-PORT
Š
STATIC RAM
IDT70V261S/L
Features
◆ _{True Dual-Ported memory cells which allow simultaneous}
access of the same memory location
◆ _{High-speed access}
– Commercial: 25/35/55ns (max.)
– Industrial: 25ns (max.)
◆ _{Low-power operation}
– IDT70V261S
Active: 300mW (typ.)
Standby: 3.3mW (typ.)
– IDT70V261L
Active: 300mW (typ.)
Standby: 660µW (typ.)
◆ _{Separate upper-byte and lower-byte control for multiplexed}
bus compatibility
◆ _{IDT70V261 easily expands data bus width to 32 bits or more}
using the Master/Slave select when cascading more than
one device
◆ _{M/S = VIH for BUSY output flag on Master}
M/S = VIL for BUSY input on Slave
◆ _{Interrupt Flag}
◆ _{On-chip port arbitration logic}
◆ _{Full on-chip hardware support of semaphore signaling}
between ports
◆ _{Fully asynchronous operation from either port}
◆ _{TTL-compatible, single 3.3V (±0.3V) power supply}
◆ _{Available in a 100-pin TQFP, Thin Quad Plastic Flatpack}
◆ _{Industrial temperature range (-40°C to +85°C) is available}
for selected speed
◆ _{Green parts available, see ordering information}
Functional Block Diagram
R/WL
UBL
R/WR
UBR
LBL
CEL
OEL
LBR
CER
OER
I/O8L-I/O15L
I/O0L-I/O7L
BUSYL^(1,2)
A13L
A0L
I/O
Control
I/O
Control
Address
Decoder
MEMORY
ARRAY
14
14
CEL
OEL
R/WL
ARBITRATION
INTERRUPT
SEMAPHORE
LOGIC
SEML
INTL⁽²⁾
NOTES:
1. (MASTER): BUSY is output; (SLAVE): BUSY is input.
2. BUSY and INT outputs are non-tri-stated push-pull.
©2012 Integrated Device Technology, Inc.
M/S
1
Address
Decoder
I/O8R-I/O15R
I/O0R-I/O7R
BUSYR ^(1,2)
A13R
A0R
CER
OER
R/WR
SEMR
INTR⁽²⁾
3040 drw 01
SEPTEMBER 2012
DSC-3040/11