|
9DBV0741 Datasheet, PDF (1/17 Pages) Integrated Circuit Systems – Integrated terminations; save 28 resistors compared to standard HCSL outputs | |||
|
7-output 1.8V HCSL Fanout Buffer
w/Zo=100ohms
9DBV0741
DATASHEET
Description
The 9DBV0741 is a member of IDT's Full-Featured PCIe
family. The device has 7 output enables for clock
management, and 3 selectable SMBus addresses. It has
integrated terminations for direct connection to 100ohm
transmission lines.
Recommended Application
PCIe Gen1-3 clock distribution in Storage, Networking,
Compute, Consumer
Output Features
⢠7 â 1-200MHz Low-Power (LP) HCSL DIF pairs
w/ZO=100ï
⢠Easy AC-coupling to other logic families, see IDT
application note AN-891
Key Specifications
⢠Additive cycle-to-cycle jitter <5ps
⢠Output-to-output skew < 60ps
⢠Additive phase jitter is <100fs rms for PCIe Gen3
⢠Additive phase jitter <300fs rms (12kHz-20MHz @125MHz)
Block Diagram
vOE(6:0)#
7
CLK_IN
CLK_IN#
vSADR
^CKPWRGD_PD#
SDATA_3.3
SCLK_3.3
CONTROL
LOGIC
Features/Benefits
⢠100ohm direct connect; saves 28 resistors and 48mm2
compared to standard HCSL
⢠41mW typical power consumption; eliminates thermal
concerns
⢠Outputs can optionally be supplied from any voltage
between 1.05V and 1.8V; maximum power savings
⢠OE# pins; support DIF power management
⢠HCSL-compatible differential input; can be driven by
common clock sources
⢠SMBus-selectable features allow optimization to customer
requirements
⢠Slew rate for each output; allows tuning for various line
lengths
⢠Differential output amplitude; allows tuning for various
application environments
⢠1MHz to 200MHz operating frequency
⢠3.3V tolerant SMBus interface works with legacy controllers
⢠Selectable SMBus addresses; multiple devices can easily
share an SMBus segment
⢠Device contains default configuration; SMBus interface not
required for device operation
⢠Space saving 40-pin 5x5mm VFQFPN; minimal board
space
DIF6
DIF5
DIF4
DIF3
DIF2
DIF1
DIF0
9DBV0741 REVISION B 03/28/16
1
©2016 Integrated Device Technology, Inc.
|
▷ |