8P79818 Datasheet, PDF (1/34 Pages) Integrated Device Technology – Programmable Low Additive Jitter 2:8 Buffer with Dividers and Universal Outputs

Programmable Low Additive Jitter 2:8
Buffer with Dividers and Universal Outputs
8P79818
Datasheet
Description
The device is intended to take 1 or 2 reference clocks, select
between them, using a pin or register selection and generate up to 8
outputs that may be the same as the reference frequency or
integer-divider versions of it.
The 8P79818 supports two output banks, each with its own divider
and power supply. All outputs in one bank would generate the same
output frequency, but each output can be individually controlled for
output type, output enable or even powered-off.
The device supports a serial port for configuration of the parameters
while in operation. The serial port can be selected to use the I²C or
SPI protocol. After power-up, all outputs will come up in LVDS mode
and may be programmed to other configurations over the serial port.
Outputs may be enabled or disabled under control of the OE input
pin.
The device can operate over the -40°C to +85°C temperature range.
Features
▪ Two differential inputs support LVPECL, LVDS, HCSL or LVCMOS
reference clocks
— Accepts input frequencies ranging from 1PPS (1Hz) to
700MHz
▪ Select which of the two input clocks is to be used as the reference
clock for which divider via pin or register selection
— Switchover will not generate any runt clock pulses on the
output
▪ Generates eight differential outputs
or eight LVCMOS outputs, Bank A only
— Differential outputs selectable as LVPECL, LVDS, CML or
HCSL
— Differential outputs support frequencies from 1PPS to 700MHz
— LVCMOS outputs support frequencies from 1PPS to 200MHz
— LVCMOS outputs in the same pair may be inverted or in-phase
relative to one another
▪ Outputs arranged in 2 banks of 4 outputs each
— Each bank supports a separate power supply of 3.3V, 2.5V or
1.8V
— 1.5V output voltage is also supported for LVCMOS, Bank A
only
— One divider per output bank, supporting divide ratios of 2...511
or divider bypass
▪ Output enable control pin
— Output enable or disable will not cause any runt pulses
▪ Register programmable via I²C / SPI serial port
— Individual output enables, output type selection and output
power-down control bits supported
— Input mux selection control bit
▪ Core voltage supply of 3.3V, 2.5V or 1.8V
▪ -40°C to +85°C ambient operating temperature
▪ Lead-free (RoHS 6) packaging
©2016 Integrated Device Technology, Inc.
1
December 19, 2016