5P49V5944 Datasheet, PDF (1/32 Pages) Integrated Device Technology – Generates up to two independent output frequencies

Programmable Clock Generator
5P49V5944
DATASHEET
Description
The 5P49V5944 is a programmable clock generator intended
for high performance consumer, networking, industrial,
computing, and data-communications applications.
Configurations may be stored in on-chip One-Time
Programmable (OTP) memory or changed using I²C
interface. This is IDTs fifth generation of programmable clock
technology (VersaClock^® 5).
The frequencies are generated from a single reference clock.
The input reference can be either a crystal or an LVCMOS
reference clock.
Two select pins allow up to 4 different configurations to be
programmed and accessible using processor GPIOs or
bootstrapping. The different selections may be used for
different operating modes (full function, partial function, partial
power-down), regional standards (US, Japan, Europe) or
system production margin testing.
The device may be configured to use one of two I²C
addresses to allow multiple devices to be used in a system.
Pin Assignment
XOUT
XIN/REF
V_DDA
GND
SD/OE
20 19 18 17 16
1
15
2
14
3
EPAD
13
4
12
5
11
6 7 8 9 10
V_DDO1
OUT1
OUT1B
GND
GND
20-pin VFQFPN
Features
• Generates up to two independent output frequencies
• High performance, low phase noise PLL, <0.7 ps RMS
typical phase jitter on outputs:
– PCIe Gen1, 2, 3 compliant clock capability
– USB 3.0 compliant clock capability
– 1 GbE and 10 GbE
• Two fractional output dividers (FODs)
• Independent Spread Spectrum capability on each output
pair
• Four banks of internal non-volatile in-system
programmable or factory programmable OTP memory
• I²C serial programming interface
• One reference LVCMOS output clock
• Two universal output pairs:
– Each configurable as one differential output pair or two
LVCMOS outputs
• I/O Standards:
– Single-ended I/Os: 1.8V to 3.3V LVCMOS
– Differential I/Os - LVPECL, LVDS and HCSL
• Input frequency ranges:
– LVCMOS Reference Clock Input (XIN/REF) – 1MHz
to 200MHz
– Crystal frequency range: 8MHz to 40MHz
• Output frequency ranges:
– LVCMOS Clock Outputs – 1MHz to 200MHz
– LVDS, LVPECL, HCSL Differential Clock Outputs –
1MHz to 350MHz
• Individually selectable output voltage (1.8V, 2.5V, 3.3V) for
each output pair
• Programmable loop bandwidth
• Programmable output to output skew
• Programmable slew rate control
• Programmable crystal load capacitance
• Individual output enable/disable
• Power-down mode
• 1.8V, 2.5V or 3.3V core V_DDD, V_DDA
• Available in 20-pin VFQFPN 3mm x 3mm package
• -40° to +85°C industrial temperature operation
5P49V5944 REVISION A 07/20/15
1
©2015 Integrated Device Technology, Inc.