ICS84329B Datasheet, PDF (12/19 Pages) Integrated Circuit Systems – 700MHZ, LOW JITTER, CRYSTAL-TO-3.3V DIFFERENTIAL LVPECL FREQUENCY SYNTHESIZER

Integrated
Circuit
Systems, Inc.
ICS84329B
700MHZ, LOW JITTER, CRYSTAL-TO-3.3V
DIFFERENTIAL LVPECL FREQUENCY SYNTHESIZER
TERMINATION FOR LVPECL OUTPUTS
The clock layout topology shown below is a typical termina-
tion for LVPECL outputs. The two different layouts mentioned
are recommended only as guidelines.
FOUT and nFOUT are low impedance follower outputs that
generate ECL/LVPECL compatible outputs. Therefore, ter-
minating resistors (DC current path to ground) or current
sources must be used for functionality. These outputs are
designed to drive 50Ω transmission lines. Matched imped-
ance techniques should be used to maximize operating
frequency and minmize signal distortion. Figures 6A and
6B show two different layouts which are recommended only
as guidelines.Other suitable clock layouts may exist and it
would be recommended that the board designers simulate
to guarantee compatibility across all printed circuit and clock
component process variations.
Z_o = 50Ω
FOUT
FIN
Z_o = 50Ω
50Ω
RTT =
1
((V_OH + V_OL) / (V_CC – 2)) – 2
Z_o
50Ω
V_CC - 2V
RTT
FOUT
3.3V
125Ω
125Ω
Z_o = 50Ω
FIN
Z_o = 50Ω
84Ω
84Ω
FIGURE 6A. LVPECL OUTPUT TERMINATION
FIGURE 6B. LVPECL OUTPUT TERMINATION
84329BV
www.icst.com/products/hiperclocks.html
12
REV. B JANUARY 18, 2006