ICS84320I-01 Datasheet, PDF (10/18 Pages) Integrated Circuit Systems – 780MHZ, CRYSTAL-TO-3.3V DIFFERENTIAL

Integrated
Circuit
Systems, Inc.
ICS84320I-01
780MHZ, CRYSTAL-TO-3.3V DIFFERENTIAL
LVPECL FREQUENCY SYNTHESIZER
APPLICATION INFORMATION
POWER SUPPLY FILTERING TECHNIQUES
As in any high speed analog circuitry, the power supply pins
are vulnerable to random noise. The ICS84320I-01 provides
separate power supplies to isolate any high switching
noise from the outputs to the internal PLL. V_CC, V_CCA, and V_CCO
should be individually connected to the power supply
plane through vias, and bypass capacitors should be
used for each pin. To achieve optimum jitter performance,
power supply isolation is required. Figure 2 illustrates how
a 24Ω resistor along with a 10μF and a .01μF bypass
capacitor should be connected to each V_CCA pin.
V_CC
V_CCA
3.3V
.01μF 24Ω
.01μF
10μF
FIGURE 2. POWER SUPPLY FILTERING
RECOMMENDATIONS FOR UNUSED INPUT AND OUTPUT PINS
INPUTS:
OUTPUTS:
CRYSTAL INPUT:
For applications not requiring the use of the crystal oscillator
input, both XTAL_IN and XTAL_OUT can be left floating.
Though not required, but for additional protection, a 1kΩ
resistor can be tied from XTAL_IN to ground.
TEST_CLK INPUT:
For applications not requiring the use of the test clock, it can
be left floating. Though not required, but for additional
protection, a 1kΩ resistor can be tied from the TEST_CLK to
ground.
LVCMOS OUTPUT:
All unused LVCMOS output can be left floating. We
recommend that there is no trace attached.
LVPECL OUTPUT
All unused LVPECL outputs can be left floating. We
recommend that there is no trace attached. Both sides of the
differential output pair should either be left floating or
terminated.
SELECT PINS:
All select pins have internal pull-ups and pull-downs;
additional resistance is not required but can be added for
additional protection. A 1kΩ resistor can be used.
84320AYI-01
www.icst.com/products/hiperclocks.html
10
REV. A AUGUST 11, 2005